ClearWater CW13 Installation Instructions Manual
Maintenance of the waste
OVERFLOW BATH SMARTWASTE
CW13
1 2
tool supplied
1
2
3
4
5
6
3
09/2019 rev.3 AT21551A01
Address
Bathroom Brands
Lake View House
Rennie Drive
Dartford
United Kingdom
DA1 5FU
info@bathroombrands.com
94°
7
8
Ø75
Ø66
Ø85
Ø49
5.6
129
9
3° max
10
87
80
Ø40
INSTALLATION INSTRUCTIONS
"Bylaw n.166/2009 - As bylaw enacted we state that some components of this product are imported from extra-Eu countries. Tested, assembled and inspected inside our factory."
Installation notes
• Ensure the air vent is installed at the top of the waste outlet as shown below.
• If temperatures fall below 0 C protect from frost.
• Only use potable mains water, and in particular avoid salt water or water containing contaminants
such as sand or grit.
• Any alterations or modifications to the product will void the warranty
• Do not use any cleaning products containing solvents, acid or alkaline corrosive substances.
• Abrasive sponges or metallic scouring pads should not be used as these could damage the
treated surfaces.
• A small amount of water may continue to drain from the waste during the opening and closing
process when the water level is below the 25cm depth.
• Any use which fails to comply with the installation notes will void the manufacturer's warranty and
liability.
+
25cm 1 cm
-
STARTS TO OPEN
At a depth of 25 cm the Smartwaste gradually starts to
open, until the waste fully opens above a depth of 36 cm.
Inlet
max 28 l/min
IMPORTANT
45°
NB:
make sure the air-vent is
positioned at 45 degrees maximum
94°
Ø85
Ø75
Ø66
87
Ø49
NB: Air vent must be positioned as shown
above.
5.6
129
3° max
Ø40
+
40cm 1 cm
-
+
25cm 1 cm
-
FULLY OPEN
Outlet
max 30 l/min
FULLY CLOSED
The drain is fully open when the water level is above 36
cm. The Smartwaste will automatically close when the
water level drops below 25cm.
80
Loading...