ClearWater clearspa Installation Instructions Manual

Installation Instructions

Clearwater Clearspa Instructions 09/06

Thank you for purchasing a Clearwater Clearspa bath tub

The following instructions will take you step by step through the installation process.

Index

1. Items provided and useful tools

2. Connection of the air pipes

3. Connection to the motor

4. System operation and maintenance

Clearwater Clearspa Instructions 09/06

Section 1 - Items provided and useful tools

The Clearspa system is already factory fitted to your bath. The additional

equipment you receive is 1) the motor, 2) the air pipe, two separate lengths, 3) 4 x

hose cuffs, 4) 4 x hose clips, 5) a non return valve and 6) touch pad. These are all

seen in the picture below.

Useful tools for the job (not supplied)

• PTFE tape

• Pliers

• Screw driver (straight and posi drive)

• Sharp knife

• Silicone sealant

Important wiring information

The spa system comes complete with at least

4m of air tubing pipe. The pipe connects the motor to the bath. It is

essential you plan firstly where the bath will be situated and secondly

where the motor will be situated. A qualified electrician must make

all electrical connections. It is essential that the electrical contractor

installs all equipment in strict compliance with I.E.E regulations 16th

Edition, 1991 or update. All electrical wiring must conform to British

Standards. We recommend that all Clearspa systems are fitted with

an (ELCB) Earth Leakage Circuit Breaker (not supplied). This

should be wired in line to the fuse box or alternatively may be wired

into a 30A ring main via a junction box. We recommend that a

appropriately fused 1amp switch spur (not supplied) be provided to

isolate the system for servicing. A 5 amp may be necessary.

Clearwater Clearspa Instructions 09/06