ClearPix CFB12DN-H2, FB12DN-H2, MFB12DN-H2, FB22DN-H2, MFB22DN-H2 Installation Manual

Installation Guide

ClearPix High Definition H.264 IP Cameras:

CFB12DN-H2, FB12DN-H2, MFB12DN-H2, CFB22DN-H2,
FB22DN-H2, MFB22DN-H2, CFB32DN-H2-WDR,
MFB32DN-H2-WDR, CFB52DN-H2 and MFB52DN-H2

920-0062B-Rev1

i

Important Safety Information

This manual provides installation and operation information and
precautions for the use of this camera. Incorrect installation could
cause an unexpected fault. Before installing this equipment read this
manual carefully. Please provide this manual to the owner of the
equipment for future use.

• Do not use near water or expose to dripping or splashing.
Do not place objects filled with liquids above the device.

• Do not expose to rain or moisture.

• For indoor use only.
If used outdoors, an approved outdoor mounting adapter
or enclosure is required. Consult with ClearPix for more
information.

• Installation must be performed by qualified personnel only,
and must conform to all local codes.

• This product is intended to be supplied by a UL Listed
Power Unit marked “Class 2” or “LPS” or “Limited Power
Source” with output rated 12 VDC or 24 VAC, 6 W min. or
Power over Ethernet (PoE), rated 48 VDC, 6 W min.

• Any external power supply connected to this product may
only be connected to another ClearPix product of the

The Warning symbol indicates the presence of dangerous
voltage within and outside the product enclosure that may
constitute a risk of electric shock, serious injury or death to
persons if proper precautions are not followed.

The Caution symbol alerts the user to the presence of hazards
that may cause minor or moderate injury to persons, damage to
property or damage to the product itself if proper precautions
are not followed.

Warning — Failure to observe the following instructions

may result in severe injury or death.

ii

same model series. External power connections must be
properly insulated.

• Do not connect directly to mains power for any reason.

• Do not install near any heat sources such as radiators,
heat registers, stoves, or other sources of heat.

• Do not subject the cables to excessive stress, heavy loads
or pinching.

• Do not open or disassemble the device. There are no user
serviceable parts.

• Refer all servicing to qualified personnel.
Servicing may be required when the device has been
damaged (such as from a liquid spill or fallen objects), has
been exposed to rain or moisture, does not operate
normally, or has been dropped.

• Do not use strong or abrasive detergents when cleaning
the device body.

• Use only accessories recommended by ClearPix.

• Use only UL-listed mounting bracket suitable for the
mounting surface and minimum 0.7 kg (1.5 lb) weight.

• Use of controls or adjustments or performance of
procedures other than those specified in this document
may result in hazardous radiation exposure.

Caution — Failure to observe the following instructions

may result in injury or damage to the camera.

iii

Regulatory Notices

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

FCC Notice

This equipment has been tested and found to comply with the limits for
a Class B computing device pursuant to Subpart B of Part 15 of FCC
rules, which are designed to provide reasonable protection against
such interference when operated in a commercial environment.
Operation of this equipment in a residential area is likely to cause
interference, in which case the user at his/her own expense will be
required to take whatever measures may be required to correct the
interference.

Changes or modifications made to this equipment not expressly
approved by ClearPix Corporation or parties authorized by ClearPix
Corporation could void the user’s authority to operate this equipment.

Disposal and Recycling Information

When this product has reached the end of its useful life, please
dispose of it according to your local environmental laws and
guidelines.

European Union:

This symbol means that according to local laws and regulations your
product should be disposed of separately from household waste. When
this product reaches its end of life, take it to a collection point
designated by local authorities. Some collection points accept products
for free. The separate collection and recycling of your product at the
time of disposal will help conserve natural resources and ensure that it
is recycled in a manner that protects human health and the
environment.

iv

Other Notices

Compilation and Publication Notice

This manual has been compiled and published covering the latest
product descriptions and specifications. The contents of this manual
and the specifications of this product are subject to change without
notice. ClearPix reserves the right to make changes without notice in
the specifications and materials contained herein and shall not be
responsible for any damages (including consequential) caused by
reliance on the materials presented, including but not limited to
typographical and other errors relating to the publication.

Intellectual Property Notice

No license is granted by implication or otherwise under any industrial
design, industrial design rights, patent, patent rights, or copyrights of
ClearPix Corporation or its licensors. Trademarks and registered
trademarks are the property of their respective owners.

Table of Contents

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Front View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Rear View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Required Tools and Materials . . . . . . . . . . . . . . . . . 3

Camera Package Contents . . . . . . . . . . . . . . . . . . . 3

Installation Steps . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Mounting the Camera . . . . . . . . . . . . . . . . . .3

Connecting Cables . . . . . . . . . . . . . . . . . . . . 4

Assigning an IP Address . . . . . . . . . . . . . . . .5

Accessing the Live Video Stream . . . . . . . . . 5

Aiming and Focusing the Camera . . . . . . . . . 6

Cable Connections . . . . . . . . . . . . . . . . . . . . . . 7

Connecting External Power . . . . . . . . . . . . . . . . . . . 7

Connecting to External Devices . . . . . . . . . . . . . . . . 8

Connecting to Microphones, Speakers

and Video Monitors . . . . . . . . . . . . . . . . . . . . . . . . . 9

LED Indicators . . . . . . . . . . . . . . . . . . . . . . . . 10

Reset to Factory Default Settings . . . . . . . . . 11

Setting the IP Address Through the ARP/Ping

Method . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 13

Limited Warranty & Technical Support . . . . 14