ClearMirror Custom, 2436BL, 18100-1836BL, 1836SL, ClearLite Series Installation Instructions Manual

ClearLite

Installation Instructions

ClearLite LED Back-lit and Side-lit,
Fog-free Vanity Mirrors

Models 18100-1836BL, 2436BL, 1836SL, 2436SL, Custom

June 2018

IMPORTANT INSTRUCTIONS

ClearLite vanity mirrors with attached ClearMirror®Defogger is designed to be powered by a
switched circuit. A 15A or 20A fuse or circuit breaker at the electrical box should protect the
circuit. Read all instructions before using the ClearLite ClearMirror.

NOTICE: All wiring must be performed by a licensed electrician. Follow the National Electrical
Code or local codes as applicable.

WARNING: Failure to follow instructions could result in death or serious injury.

Installation

COMPONENTS OF THE CLEARLITE

INSTALL JUNCTION BOX

Position junction box near the center of the mirror as shown in
Figure 1.

• Cut a 2” x 3” section of drywall

• Install 2” x 3” remodeler’s electrical junction box

Studs

Junction Box

Figure 1. Junction box installation.