Classic Crafts Door User Manual

Classic-Craft

®

Fiberglass Entry Door Systems

Residential Lifetime Limited Warranty

1. WHAT THIS LIMITED WARRANTY COVERS AND HOW LONG
Classic-Craft® Door Systems (“Product”) includes the door, any applied or inserted panels, glass lite inserts, wood grilles, hinges, weather-stripping, door
bottom gaskets, corner seals, door sill, multi-point lock system and astragal. This Limited Warranty applies only when all of these parts are genuine Therma-Tru
components. Except for wood grilles, other all-wood parts including but not limited to door jambs, mull posts, brickmould, and mull casing are not covered by this
Limited Warranty.

a) COVERAGE
Subject to the limitations and exclusions below, and for the duration of the applicable Warranty Period, Therma-Tru Corp. (“Seller”) warrants: (1) that the
Product’s non-glass components will be free from non-conformities in material and workmanship; and (2) the Product’s glass components will be free from non­conformities in material and workmanship resulting in internal glazing failure, seal failure, internal insert slippage, and permanent and material visual obstruction
from moisture or dust film formation in the air space of the sealed glass unit.

b) WARRANTY PERIOD
Residential Warranty Holder: Lifetime from the date the Product was originally purchased from an authorized dealer. Not transferable.

Commercial/Multi-Resident Warranty Holder: 3 years from the earlier of the date Product was shipped from the Seller or an authorized dealer; transferable to a
successor non-residential owner during and for any balance of the 3 year Warranty Period.

c) WARRANTY HOLDER CLASSIFICATIONS
RESIDENTIAL WARRANTY HOLDERS: If the Product is installed in (i) a new residential dwelling and the first occupant owns the dwelling or (ii) an existing
owner-occupied residential dwelling, and in each case, at the time of installation such owner is also responsible for Product replacement, then that owner is a
Residential Warranty Holder. For example, assume the Product is installed in a condominium unit (a “dwelling”) in a multi-resident building. If the first occupant of
the condominium unit is the first owner of that unit and is also responsible for Product replacement, then that owner is a Residential Warranty Holder; however, if
the owner is not the first occupant or if someone else other than the owner (for example, the condominium association) is responsible for Product replacement,
then the owner is not a Residential Warranty Holder.

COMMERCIAL/MULTI-RESIDENT WARRANTY HOLDERS: If the Product is installed under conditions in which no one qualifies as a Residential Warranty Holder
as described above, then the warranty holder is the owner of the dwelling or building in which the Product has been installed at the time of installation (and its
builder and contractor). That owner is classified as a Commercial/Multi-Resident Warranty Holder. For example, this includes owners of commercial or investment
buildings, or multi-resident premises in which the occupant is not responsible for Product replacement whether or not the occupant owns the residential dwelling
unit in the premises (including by example, certain condominiums, town homes, duplexes, apartments, cooperatives).

2. WHAT THIS LIMITED WARRANTY DOES NOT COVER

a) GENERALLY
This Limited Warranty does not include non-conformities or damages attributable to or arising from:

• Minor scratches or minor visual imperfections

• Negligence; improper use, assembly of the Product (door systems) other than by Therma-Tru (Seller), installation, nishing, maintenance (including failure to

maintain finish, see note below) or operation inconsistent with Seller’s recommendations and written instructions that are generally available in Seller’s Product
Manual as updated by bulletins or other written communications or on Seller’s Worldwide website www.thermatru.com. **

• Improper pre-installation storage, including inadequate shelter or inadequate venting of shipping wrap in humid locations

• Misapplication or faulty building design or construction, including inadequate ashings or caulking

• Product reinstalled after removal from its original installation

• Normal wear and tear, including without limitation, wear and tear to weather-stripping or door bottom gaskets or the multi-point locking system

NOTE: **All Therma-Tru Classic-Craft door systems must be finished within 6 months of the installation date for continued warranty coverage however, all bare
or unprotected wood surfaces (such as door frames) should be primed and painted and top coated within the lesser of 2 weeks of installation or exposure to
weather. All doors must have all 6 sides finished and on out-swing doors the sides, top and bottom must be inspected and maintained as regularly as all other
surfaces.

b) GLASS
This Limited Warranty does not include:

• Minor variations in glass color or imperfections that do not affect the glass’s structural integrity or do not permanently and materially obstruct vision from

moisture formation between the panes

• Glass covered with after-market window lms

• Accidental glass breakage, including caused by debris or foreign objects striking the glass, or breakage that may occur under conditions exceeding the

Product’s performance parameters

• Condensation, frost or mold resulting from humidity within the building and interior/exterior temperature differentials

• Stresses from localized heat which cause excessive temperature differentials over the glass

• Post-manufacture dissipation of inert gases (as argon), or the amount of gas in Products with inert gas-lled insulating glass

• Scratches or other imperfections, unless readily observable more than four feet away

c) CERTAIN ENVIRONMENTAL CONDITIONS
This Limited Warranty does not guarantee safety for persons or property, nor make a premises hurricane-proof or impact-proof. Follow weather and news reports
in order to assess severe weather situations and obey local authorities’ shelter and evacuation orders. This Limited Warranty does not cover damage attributable

to or caused by acts of God that include, but are not limited to stresses, high winds, oods, re and other conditions that exceed Product designs that are

test evaluated and certified as referenced in Seller’s published literature. CERTIFICATION APPROVAL, RATING, AND REFERENCES TO OTHER PERFORMANCE
STANDARDS MEAN THAT THE PRODUCT MEETS THE ESTABLISHED SPECIFICATION PARAMETERS OF THE CERTIFICATION PROCESS OR STANDARD TESTING
AT THE TIME THE PRODUCT IS MANUFACUTURED. However, with exposure over time to environmental conditions, including by example, high wind events and
other forces of nature, the Product will be subjected to normal and abnormal wear and its performance capability may change. Consult local building code laws,
and the certification and rating agencies published materials and websites, for guidelines on the standards necessary to meet all regulations and codes in your
area. Product features designed to help address pressurization of a building during high-wind or other severe storm events are not a guarantee against water
and air infiltration. Seller is not responsible for claims or damages caused by water or air infiltration. PRODUCT SELECTION IS THE SOLE RESPONSIBILITY OF THE
WARRANTY HOLDER.

d) DAMAGE FROM FAILURE TO INSPECT PRODUCT FOLLOWING EACH HIGH-WIND OR IMPACT EVENT
Product that is subject to any high wind event or the possibility of having been impacted by wind-borne debris should be promptly inspected by the Warranty
Holder or by a building professional if the Warranty Holder cannot perform this inspection themselves or if there is concern about Product damage. Proper care
and maintenance of the Product is the responsibility of the Warranty Holder and failure to do so may void the Limited Warranty. Although a Product may appear
to be in good working condition, the effects of such an event(s) may have adversely affected the ability of the Product to provide subsequent protection against
another such event.

e) MULTI-POINT LOCK SYSTEM
The mechanical and locking mechanism of the Seller’s multi-point locking system is warranted against non-conformities in materials and workmanship for
the Warranty Holder’s Warranty Period. This Limited Warranty does NOT COVER THE FINISH, including, but not limited to, finish discoloration or scratches and
abrasions. For clarification, this Limited Warranty also does not cover non-conformities or damages described in Sections 2a, 2c and 2d above.

3. THIS LIMITED WARRANTY’S EXCLUSIVE REMEDY
If the Product or any components fail to meet this Limited Warranty, Seller’s sole obligation is, to either (as Seller elects): a) repair the component (color matching
not guaranteed); or b) provide replacement component(s) to the Warranty Holder or the Seller’s dealer designated (color matching not guaranteed); or d) refund
the Warranty Holder’s purchase price (the lesser of the original Product/component purchase price or the original catalog list price). Repaired or replaced
components are warranted only on the same terms and for the remainder of the Warranty Period. Seller reserves the right to discontinue or change any Product.
If the Product or component is not available, Seller may select and provide a replacement Product or component of equal quality and price. This is the Warranty
Holder’s sole and exclusive remedy for the Product under this Limited Warranty. By example but not limitation, this Limited Warranty does not cover the following
costs and expenses: (i) labor for removing, reinstalling, refinishing Product (or other materials that are removed, reinstalled or refinished to repair or replace the
Product); (ii) shipping/ freight expenses to return the Product to Seller; (iii) normal maintenance; or (iv) consequential, special, or indirect losses or damages of
any kind.

4. DISCLAIMER OF WARRANTIES
THIS LIMITED WARRANTY IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES NOT EXPRESSLY SET FORTH HEREIN, EXPRESSED OR IMPLIED BY
OPERATION OF LAW OR OTHERWISE, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE. TO THE EXTENT THAT ANY IMPLIED WARRANTIES MAY NONETHELESS EXIST BY OPERATION OF LAW, SUCH WARRANTIES ARE LIMITED TO THE
DURATION PROVIDED BY LAW. SOME STATES/PROVINCES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE
LIMITATIONS MAY NOT APPLY. SELLER DOES NOT AUTHORIZE ANYONE TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH PRODUCTS.

5. LIMITATION OF LIABILITY
SELLER’S SOLE LIABILITY UNDER THIS LIMITED WARRANTY IS REPLACEMENT, REPAIR, OR REFUND OF THE PURCHASE PRICE AS SET FORTH ABOVE. IN
NO EVENT, WILL SELLER BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES INCLUDING, BUT NOT LIMITED TO,
DAMAGE OF ANY KIND TO A PREMISES, LOSS OF PRODUCT USE, REINSTALLATION, LABOR, REMOVAL, REFINISHING, TEMPORARY/PERMANENT RELOCATION
OF RESIDENTS OR PROPERTY, LOSS OF PROFITS/REVENUE, INTEREST, LOST GOODWILL, WORK STOPPAGE, IMPAIRMENT OF OTHER GOODS OR WORK,
INCREASED OPERATING EXPENSES, EMOTIONAL DISTRESS CLAIMS, OR CLAIMS OF THIRD PARTIES FOR SUCH DAMAGES, WHETHER BASED ON CONTRACT,
WARRANTY, TORT (INCLUDING, BUT NOT LIMITED TO, STRICT LIABILITY OR NEGLIGENCE) OR OTHERWISE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.) SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY. THIS LIMITED WARRANTY PROVIDES SPECIFIC LEGAL RIGHTS BUT WARRANTY HOLDER MAY HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE. IF THIS LIMITED WARRANTY IS DEEMED TO HAVE FAILED OF ITS ESSENTIAL PURPOSE, IN NO EVENT WILL SELLER’S ENTIRE LIABILITY
EXCEED THE LESSER OF THE PRODUCT’S OR THE NON-CONFORMING COMPONENT’S PURCHASE PRICE.

6. CLAIMS
Claims must be initiated during the Warranty Period. To initiate a claim, please contact the builder, dealer or contractor who installed or sold the Product. If that
party is unknown or unreachable, contact Therma-Tru Corp., 1750 Indian Wood Circle, Maumee, Ohio 43537 at 800-537-5322 or at www.thermatru.com.
Claimant will be required to provide proof of premises ownership and the date of Product purchase and may be required to return the Product or component to
Seller (at Claimant’s expense).

Effective November 1, 2009
MAWC0594