Turning the warewasher on
Loading the warewasher
Push the ‘ON’ button, the button will flash amber to indicate
pre-heating and water filling of the machine. You can continue
to prepare the machine whilst this process occurs.
Open the hood to load a basket. Before loading, ensure debris
is rinsed from the items. With the basket in place, close the
hood.
See the User Manual for loading information.
2
1
3
Selecting a wash program (optional)
If you do not require the default
program then choose your
desired program using the
SELECT button until the display
shows the program you require.
4
Confirming your selection
Cycle indicator will illuminate blue to show a program selection
has been made.
5
Warewasher start cycle
Once the temperature and water cycle is complete, the amber
START button will illuminate green and your program will start.
P500 P500A P500AS
P500AWS P500ASWS
Pass Through Warewasher
Quick User Guide
1.5 Mins
3 Mins
5 Mins
*
*
Default program
Caution
Only use this Quick User Guide after the
Warewasher has been fully commissioned.
See Section 5 in the User Manual.
Low Salt Warning
6
Draining Down
There are two ways to drain down the warewasher lifting the
Hood up and down and via the control buttons.
• Push OFF the warewasher
on/off button (for both ways)
• Push on the cycle button
7
The icon indicates your machine is low on salt.
The salt should be replenished as soon as possible to
avoid limescale from building up in your machine.
To refill the Salt Reservoir follow the instructions below:
1. Open the hood to the machine.
2. Remove the Basket Ramp (1).
3. Remove the Salt Reservoir Cap at the ront right hand corner of
the Wash Chamber (2).
4. Using the Salt Funnel supplied fill the Reservoir with granulated
salt.
5. Wipe away any excess or spilt salt from the Chamber and the
Reservoir opening.
6. Refit the Cap to the Reservoir, ensure that the Cap is fitted flat
and secure.
7. Close the hood and drain down the machine to remove the
salt water.
Document Number 30014455 Rev A 070319
P500 P500A P500AS
P500AWS P500ASWS
Pass Through Warewasher
Quick User Guide
1
3
4
5
2
6
7
9
8
Daily Cleaning
The interior of the machine should be cleaned after each
service when the machine is drained down.
• Remove and clean the top Rinse and Wash Arms (4).
• Remove the Basket Ramp (1).
• Remove and clean the bottom Rinse and Wash Arms (5).
• Remove and clean the Primary Filters (6).
• Remove and clean the Secondary Filter (7).
• Clean the interior of the Wash Tank with a sponge and/or brush for all apertures and outlets.
• Clean around the hood and sliding rails.
• Use a small bottle brush followed by a trigger spray bottle with a jet nozzle to spray the ball in the
Anti-Syphon Device (pumped drain warewashers only) (8 and 9).
Ensure all Arms and Filters are refitted to the machine and the hood is closed before turning it on.
8
• The cycle indicator
flashes blue
• Flashing stops the drain
down cycle is complete.
Note
The warewasher must be OFF to drain down.
• Lift the Hood up and down.
OR
Before first use, when filling with salt, ensure the Salt
Reservoir has been filled with fresh water. See Section 5
Commissioning in the User Manual.
Loading...