Clarke WS 2, 6000820 User guide

WELDING SCREEN

Model No. WS2

Part No. 6000820

ASSEMBLY INSTRUCTIONS

Your Welding Curtain comprises the following components: Feet............................................................. 2 pcs

Casters with brake (A) .............................. 2 pcs

Casters Plain (B)......................................... 2 pcs

Side Members............................................ 2 pcs

Cross Members.......................................... 2 pcs

Hex. socket head screws M5x10 (C)...... 12 pcs

Hex. socket head screws M5x20 (D)....... 4 pcs

Flat Washers (E) ......................................... 4 pcs

Hex. Wrench (F)......................................... 1 pc

End Caps (G)............................................. 4 pcs

Curtain Clips (H) .......................................13 pcs

Curtains ...................................................... 2 pcs

Should there be any deficiency, please contact
your Clarke dealer immediately

CLARKE International. Head Office: Hemnall Street, Essex, CM16 4LG. Tel: [phone]. Service 020 8988 7400

1. Attach a caster to the end of each foot,

using a M5x20mm hex. socket head screw
with a flat washer.

Ensure one plain caster and one with a brake
device is fitted to each foot (see Fig.2).

FIG.2

2. Bolt a side member to each

foot, using the hex. socket head
screws provided

FIG.1

3. Bolt the cross members to the side

members, using the hex. socket head
screws provided

4. Attach the curtains to the upper cross member using

the ‘C’ clips provided, in the manner shown in the picture
on the reverse.

FIG.3

FIG.4

5. Finally, press an end cap into the end of each foot

The structure may be prevented from moving by applying
the brakes attached to two of the casters.

Press down with the foot, on the brake plate so that the
brake is applied as shown in Fig.4