Page 1
SAFETY CLEAR SPECTACLES
MODEL NO: SCS2
PART NO: 8133816
USER INSTRUCTIONS
ORIGINAL INSTRUCTIONS DL0722 REV 1
Page 2
INTRODUCTION
Thank you for purchasing this CLARKE product. Before attempting to use this
product, please read these instructions carefully. In doing so you will ensure
your safety and you can look forward to your purchase giving you long and
satisfactory service.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for its intended purpose. Faulty goods
should be returned to their place of purchase, no product can be returned to
us without prior permission.
This guarantee does not effect your statutory rights.
SPECIFICATIONS
Optical class: 1
Material lenses: Polycarbonate
Arms: Nylon
MARKINGS ON THE PRODUCT
F:- protection against low energy impact (45m/s) from high-speed particles at
room temperature only.
MATERIALS DECLARATION
No parts of this product is made of materials that are known to cause skin
irritation. However, materials that come into contact with the skin can cause
allergic reactions to certain susceptible individuals.
2
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Page 3
USING SAFETY SPECTACLES
APPLICATION
These safety spectacles are designed for eye protection against moderate
impact hazards but are not unbreakable and do not provide unlimited eye
protection. They are designed to protect the user against eye injuries through
impact of flying particles or droplets. The safety spectacles are not intended
for welding use.
The safety spectacles have been designed for your personal safety and must
be worn for the whole duration of exposure to hazards. You should leave the
work area if dizziness or eye irritation occurs or if the safety spectacles become
damaged.
SAFETY WARNINGS
1. Do not modify or alter the safety spectacles in any way.
2. Pitted or scratched lenses reduce vision, seriously reduce protection and
should be replaced immediately.
3. Materials that come into contact with the skin can cause allergic reactions
to certain susceptible individuals.
4. If in doubt, check with supervisory personnel to ensure you have the
correct level of protection relative to working conditions. If necessary
consult relevant European Standards.
5. The clear lenses of these safety spectacles offer no protection against
optical radiation given off during welding or cutting work.
CLEANING, MAINTENANCE AND STORAGE
1. Do not use abrasive materials for cleaning the safety spectacles. Always
clean either with optical cleaning solution, a cleaning solution very low in
alcohol or in warm soapy water. Rinse and dry with a soft cloth.
2. Parts that come into contact with the skin of different users should be
regularly disinfected.
3. It is recommended to store the spectacles in a clean, dry polythene bag
when not in use. Store in a dry place sheltered from UV light, ideally in a
protective case. Ideally, this should be between 5
o
C and 40oC.
4. If the lenses become damaged the spectacles must be replaced.
3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Page 4
DECLARATION OF CONFORMITY
Parts & Service 0208 988 7400
E-mail: [email protected] or [email protected]
Clarke International, Hemnall Street, Epping, Essex CM16 4LG
4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Loading...