Clarke MA30 13B Use And Maintenance

Use and Maintenance

™

MA30

13B

ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.

1. Disconnect the battery charger cord
from the machine and electrical
outlet.

2. Fill the solution tank with water.
The water temperature must not
exceed 105° F (40° C).

3. The tank cap can be used for dosing
the detergent. One full cap is 30 ml
giving 0.5% detergent of the 1.6 gal
(6 L) tank capacity. (*)

4. Adjust the handle to the desired
height. Turn the machine on with

the power button.

5. Lift the pedal to lower the machine
and start working.

6. Grab the handles to activate the
brush and solution flow, then start
cleaning the floor.

When finished using

7. Press the solution button to select
the type of cleaning required.

8. For sweeping functions, lift/lock the
right lever to lift the front squeegees
in order to collect light debris.

9. For double scrubbing, press the
vacuum suction button to switch the
vacuum off.

10. Turn the machine off with the
power button.

11. For transporting and parking the
machine, push the pedal down
(slightly lift the front of the machine
by tilting the handlebar).

12. Empty the recovery and solution
tanks. Clean them out with water.

13. Remove the cover and clean it with
hot water. Remove the ball float
cage along with the float and clean
them thoroughly.

14. Check and clean the solution and
vacuum filters regularly.

15. Remove the squeegee bars.
Remove the cylindrical brush by

turning the side knob clockwise.

17. Clean the debris collection tray.16. Clean the squeegee bars and the
cylindrical brush with water.
Check for wear and replace
when necessary.

(*) ALWAYS FOLLOW THE DETERGENT DOSING RECOMMENDATION ON THE LABEL OF THE CHEMICAL PRODUCT USED.

9435 Winnetka Avenue North • Brooklyn Park, MN 55445
Phone: [phone] • Fax: [phone]

240 Superior Boulevard • Mississauga, Ontario, Canada L5T 2L2

18. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product.

19. Charge the batteries: Connect
the battery charger cord from the
machine to an electical outlet.

20. Store the machine in a clean and
dry place.

Phone: [phone] • Fa x: 8 0 0.26 3 . 5111

Troubleshooting

™

MA30

13B

ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.

The machine
doesn’t work
as it should?

(*) For these causes the maintenance

The suction
doesn’t work

1. Check if the battery is charged. 2. Check if the battery is correctly
fitting in the machine. (*)

procedure must be performed by an
authorized Clarke Service Center.

For further information refer to the
Service Manual, available at any
Clarke Service Center.

3. Machine fault indicated by LED’s
blinking. (*)

as it should?

1. Check if the recovery tank is full. 2. Check if dirt and debris are clogging
the squeegee inlet and if the blades
are worn or damaged.

3. Rinse the inside of the duct recovery
hose with water.

4. Check if the float cage is clean.

The machine
doesn’t clean
as it should?

1. Check to see if the solution filter is
dirty. Clean it if necessary.

2. Check if the holes in solution
dispensers are clogged. Remove
them and clean if needed.

3. Check to make sure the quick
connect valve is not leaking.

The brush
doesn’t work
as it should?

1. Adjust the brush pressure by turning
the regulation knob.

2. Check for brush wear, and make
sure that it is installed correctly.

3. Check to see if there is debris that is
preventing the brush from rotating.

9435 Winnetka Avenue North • Brooklyn Park, MN 55445
Phone: [phone] • Fax: [phone]

240 Superior Boulevard • Mississauga, Ontario, Canada L5T 2L2
Phone: [phone] • Fa x: 8 0 0.26 3 . 5111