Clarke DAF 1, 4500155 User guide

DIGITAL ANGLE FINDER

MODEL: DAF-1

Part No: 4500155

OPERATING MANUAL

11/08

INTRODUCTION

Thank you for purchasing this CLARKE product

Before attempting to use the product, it is essential that you read this manual
thoroughly and carefully follow all instructions given. In doing so you will
ensure the safety of yourself and that of others around you, and you can also
look forward to the product giving you long and satisfactory service.

GUARANTEE

This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase.

This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended.

Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.

This guarantee does not effect your statutory rights.

ENVIRONMENTAL PROTECTION

Do not dispose of this product with general household waste. All tools,
acessories and packaging should be sorted, taken to a re-cycling
centre and disposed of appropriately.

SPECIFICATION

metI noitacificepS

egnargnirusaeM)sgnittes-4(seerged063-0

ecnarelotgnirusaem/ycaruccAeerged1.0

htgnelmrAmm502

yal

psiDDCLthgiehretcarahcmm21

thgieW smarg054

)wxhxl(snoisnemiD32x05xx562

tnemeriuqeRyrettaByrettabmuihtiL2302r

2

CV3

DIGITAL ANGLE FINDER

The DAF-1 is an inovative Angle Finder with LCD display. It can be used for
measuring, marking and setting angles with the following features:

• Absolute and relative measurement display

• Easy calibration & zero setting

• Lockable blade at any angle through 360 degrees

• Level bubble located on top

• Aluminium body & stainless steel arm

• 2000 hours Lithium battery life

Moving blade

Fixed blade/body

LCD display

Locking knob

Spirit Level on top

Please note that the details and specifications contained herein are correct at the
time of going to print. However, CLARKE International reserve the right to change
specifications at any time without prior notice.

3

OPERATING INSTRUCTIONS

PUSH BUTTONS & LCD

• Analogue quadrant indicated

• High resolution 0.05

• “ABS” mode

• Conversion between absolute
measurement and relative measure­ment by short press

• Holding

• Press more than 8 seconds to turn
off, short press to shut off LCD

ABS SETTING

In ABS mode the device will;

• automatically record the original ZERO position after powering off

• display always reads upright

In ABS mode, a long press on the ZERO/ABS button for 5 seconds will set the
ZERO position of the movable blade.

Position the moving blade in the same plane as the fixed blade.

4

USE OF THE SPIRIT LEVEL

Standard level surfce

USE OF THE ANALOGUE QUADRANT/MOVING BLADE

Plumb
surface for
measuring

5

DIGITAL READOUTS

Both internal and external angles can be measured, the reading displayed as
a positive or negative angle.

6

LOCKING POSITIONS FOR A SPECIFIC MEASURING RANGE

A different measuring angle can be chosen by locking the arm at one of four
different locking holes. With the arm locked precisely in position,the
workpiece can be marked out accurately.

REPLACING THE BATTERY

Press and twist with the thumb/fingrer tips to loosen the battery cover and
remove the cover.

Replace the old battery with a new one. A single CR2032 (3volt) button cell is
required.

Put the battery cover back on and twist to secure.

GENERAL CARE OF THIS PRODUCT

If dirty, always clean the angle finder with mild liquid soap and a damp cloth.
never immerse the unit in water.

7