Clarke CHT 431, 1801431 User guide

HUB AND BEARING

INSTALLER

MODEL No: CHT 431

Part No: 1801431

GUARANTEE

This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase. This guarantee is invalid if the product is found to have been abused
or tampered with in any way, or not used for the purpose for which it was
intended.

Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.

This guarantee does not effect your statutory rights.

GENERAL CONSIDERATIONS

WARNING:

The vehicle must be properly prepared, and adequately supported on axle

stands, on firm level ground, before any operation using this tool is performed.

The tool may be used for installing seals and bearings into the hubs of most vehicles.
It may also be used for pulling hubs where the wheel flange is drilled and tapped
so that the road wheel is secured with bolts.

COMPONENTS

Fig. 1

Part No Part No

A1 55.5mm (2-3/16”) ZHCHT43101

A2 59mm (2-11/32”) ZHCHT43102

A3 62mm (2-7/16”) ZHCHT43103

A4 65mm (2-9/16”) ZHCHT43104

A5 66mm (2-19/32”) ZHCHT43105

A6 71.5mm (2-13/16”) ZHCHT43106

A7 73mm (2-7/8”) ZHCHT43107

A8 78mm (3-3/32”) ZHCHT43108

A9 84mm (3-5/16”) ZHCHT43109

B 38MM (1-1/2”) ZHCHT43110

C 76mm (3”) ZHCHT43111

D1 86mm (3-13/32”) ZHCHT43112

D2 91mm (3-19/32”) ZHCHT43113

E Bolt ZHCHT43114

F Long Nut ZHCHT43115

G Thrust Bearing ZHCHT43116

H Flat Washer ZHCHT43117

M1 M12x90 ZHCHT43118

M2 M14x90 ZHCHT43119

METHODS OF USE

1. Installing seals/bearings

Assemble the tool in the manner shown in the example below, selecting the
components which fit thejob in hand. Ensure the large nut is screwed fully on to
the bolt, and all components are entirely square before pulling down on the bolt.

Fig. 2

2. Hub Pulling

It is possible to remove hubs from the swivel joint,
using the bolts (M) supplied.

The appropriate size bolts are screwed into the
holes in the wheel flange, so that they bear up
against the surface of the swivel joint.

Screw in the bolts PROGRESSIVELY to pull off the
hub.

For hubs where the wheel is mounted on studs, a
slide hammer puller type puller must be used.

For Spare Parts and Service, please contact your nearest dealer,

or CLARKE International, on one of the following numbers.

PARTS & SERVICE TEL: [phone]

PARTS & SERVICE FAX: [phone]

or e-mail as follows:

PARTS: [e-mail]

SERVICE: [e-mail]

Fig. 3