Page 1
ALUMINIUM CAR CREEPER
Model CMC55
Part Number 7630192
ASSEMBLY INSTRUCTIONS
Thank you for purchasing this CLARKE Aluminium Car Creeper.
Please read this leaflet thoroughly and follow the instructions carefully, in doing so
you will ensure the safety of yourself and that of others around you, and you can
look forward to the creeper giving you long and satisfactory service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered
with in any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product
can be returned to us without prior permission.
This guarantee does not effect your statutory rights.
SAFETY PRECAUTIONS
1. NEVER allow the creeper to be used as a plaything. Keep children away at all times...this
is NOT a toy.
2. Never leave the creeper unattended. When not in use, it should be stored carefully and not
left lying around for others to trip over. Be aware that this could be a serious hazard.
3. Always use your creeper on a hard level surface, not in the vicinity of drains, holes,
curbs, cracks etc., as this could cause serious damage to the castors.
4. ALWAYS check your creeper regularly for signs of damage, and if any is apparent,
have it repaired before putting back into use. Remember, broken, worn or missing
parts could result in injury.
Page 2
ASSEMBLY
Should damage, to any of the components, have occurred during transit, please notify
your Clarke dealer immediately.
1. Slip the lockwasher (3) on to the barrel nut (2) and inset into the pre-drilled holes in the
frame (5), from the top.
2. From the bottom, insert the castor into the barrel nut and tighten by hand as far as possible,
ensuring the square shoulder on the castor locates neatly in the square hole on the underside
of the frame..
3. Using a 5mm Hex. wrench (not supplied), in the hex recess in the barrel nut...tighten all
6 Nuts.
The Creeper is maintenance free, but should any damage occur, spare parts are available
from Clarke International, details of which are shown below.
Item Description Part No.
1 Headrest. CMS5501
2 Barrel Nut CMS5502
3 Lockwasher CMS5503
4 2 1/2” Castor CMS5504
5 Frame n/a
Weight ............................................. 4kg
Max. Load ....................................... 180kg (400lbs)
Dimensions...................................... 1050x430x80mm
Part No. ........................................... 7630192
For Spare Parts, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
TEL: 020 8988 7400
FAX: 020 8558 3622
or e-mail as follows:
PARTS: [email protected]
Loading...