Clam EDGE Operating And Parts Manual
EDGE™ POWER AUGERS
OPERATING AND PARTS MANUAL
p/n 104081
Clam
Corporation
12135 Brockton Lane N. •Rogers, MN 55374
Phone ( 763)231-4120 • Fax
www.clamoutdoors.com
(763)231-4121
Please follow these Important safety precautions regarding your
Clam Edge auger during use
1. This product is solely intended for use in drilling holes in the ice. It should be handled and used with
caution as there are very sharp edges on the blades and a spinning auger during use that could
cause bodily harm if not used properly.
2. Keep all articles of clothing as well as body parts away from the powerhead and spinning auger
during operation at all times. Your auger is a tool that should be handled with caution.
3. This product should not be altered in any way from its original, purchased condition unless with an
authorized Clam accessory or part. Using parts other than from Clam could be potentially damaging
to the product or dangerous to the user, and will void all warranties by the manufacturer.
4. Person(s) using this auger should weigh a minimum of 100 lbs., and not be under the influence of
any chemicals or mind-altering substances. The Edge auger operates with a lot of torque and speed,
and the operator must be fully aware and prepared for that during its use.
5. If by any chance, something is not in proper working condition on your auger-recoil, auger, throttle,
etc…, do not use it. Bring it to an authorized service center for repair.
6. Verify all hardware-especially the 4 bolts on the blades and the one socket head bolt holding the
auger to the powerhead, are secure prior to usage.
7. If by any chance, the auger stops spinning during cutting, release the throttle and pull up on the
auger to release the torque. Then reapply the throttle and continue drilling.
8. When the auger is not in use, turn off the power by pressing the stop switch. Do not let it run while
leaving your auger unattended.
2
1. Recoil (starter) Handle
2. Fuel
Cap
3. Fuel Tank
4. Full Fuel Level
5. Decompression Button
6. Throttle Lever
7. Air Filter Cover
8. Throttle Ro d
9. Choke Lever
10. Transmission
11. Stop Switch
12. Spark Plug
Cap
13. Recoil
14. Muffler Guard
15.
Muffler
16. Rigid Handle System
Loading...