claber Tempo Hybrid User Manual
User manual
Tempo Hybrid
Tempo Hybrid
Page 1
INSTALLATION - Where to install the TEMPO HYBRID. Install the water timer outside, in a bright area, avoiding
any areas which are in shade or dark.
When choosing the installation position, observe the indications provided below.
User manual
1
1
> 45°
< 45°
angle exceeding 45°
position RECOMMENDED
angle LESS than 45°
position
NOT RECOMMENDED
2
2
angle exceeding 90°
position RECOMMENDED
> 90°
angle LESS than 90°
position
NOT RECOMMENDED
< 90°
Tempo Hybrid (cod.): 8487
INSTALLATION - How to install the TEMPO HYBRID. (1) The spout of the tap should have a 3/4" threaded male
connector, if not, use an adapter. Screw the screw collar of the 3/4” female tting onto the tap. Warning: only
tighten the ring nut by hand and not with tools (ex. pliers). (2) Connect the watering line to the quick-click or
threaded connector using the appropriate ttings.
1
1
3/4”
2
2
- Do not install the water timer
inside valve boxes, below ground
level or indoors.
- Do not use the timer with chemicals or liquids other than water.
- Do not use the water timer with
operating pressures lower than
0.2 bar (2,9 psi) or higher than 12
bar (174 psi).
Tempo Hybrid (cod.): 8487
User manual
Tempo Hybrid
Tempo Hybrid
Page 2
INSTALLATION - Sostituzione batteria. To operate, the water timer uses mainly solar energy. To turn on the
backlit display or when there is not enough solar energy (for example, after a few days of rain), the back-up AA
1.5 V (LR6) Alkaline battery will automatically be used to ensure correct operation of the water timer.
The “sun” symbol on the display:
- if this symbol ashes, it indicates there is not enough light (therefore the water timer will be battery operated)
- if this symbol remains active, it indicates that there is sucient light (therefore the water timer will operate on
solar energy).
If the battery used is new and the water timer is installed correctly, he life cycle of the battery will be approximately 4 years (or until the expiry date if this is less than 4 years).
The life cycle of the battery therefore depends on:
- environmental conditions (number of sunny/rainy days);
- where the water timer is installed;
- how often the backlit function is used.
The water timer is protected against reverse polarity of the battery and automatically checks the battery level.
Indicator of
battery charge
User manual
(FLASHING)
Battery
Charge state
Tempo Hybrid (cod.): 8487
INSTALLATION - Battery replacement. When the battery is at:
- if any key is pressed (for example, display back lighting), programming is suspended. To restore programming,
replace the battery;
- if NO key is pressed, programming is in any case carried out (only if there is enough sunlight (“sun” symbol
permanently activated).
To t or replace the batteries, proceed as follows: (1) Fully press the side key () and simultaneously detach the
front part of the water timer (2). Remove the at batteries, if in place. (3) Fit the new battery in the support
observing the correct polarity. Ret the water timer by joining the two parts until you hear the "click" of the
coupling of the side key.
1
1
completely
charged
2
2
Battery
partially
charged
Discharged
battery
to be replaced
3
3
Depleted
battery
to be replaced
Tempo Hybrid (cod.): 8487
AA
1,5 V
AA Alkaline
+
DISPLAY - Time page.
Tempo Hybrid
Tempo Hybrid
Page 3
User manual
User manual
Please refer to
Use with
Rain Sensor:
Please refer to
Use:
Battery status:
Water timer
Rain Sensor (if present)
Plus mode indicates
if the programmes
will be carried out on
odd or even days
* S= sunday / M= Monday / T= Tuesday / W= Wednesday
T= Thursday / F= Friday / S= Saturday
if the plus function is set to ,there is also an indication of whether the current day is odd or even .
When operating with the 12-hour clock,
always indicate p.M. Or a.M.
Current time
Current day*
Start and run time
of next watering cycle
Days on which the programme
is to be carried out with the next
watering cycle
Tempo Hybrid (cod.): 8487
DISPLAY - Programming page.
Total watering run time
For the week
Start time of the
programme displayed
(for example, 2)
If the plus function is set to ,
this indicates if the programmes
will be carried out on odd or
even days
Current day*
If ashing, this indicates
that watering is in
progress
Number of the
programme which is
being set or displayed
(for example, 2)
Run time of programmed
displayed (for example, 2)
Days on which the displayed
programme will be carried out
* S= sunday / M= Monday / T= Tuesday / W= Wednesday
T= Thursday / F= Friday / S= Saturday
if the plus function is set to ,there is also an indication of whether the current day is odd or even .
Tempo Hybrid (cod.): 8487
Loading...