Cklite CK-303, CK-303DMX User Manual

1000W SMOKE MACHINE

Item No： CK-303

USER MANUAL

www.cklight.com.cn

©Copyright

Please read these instructions carefully before use.

Introduction

Congratulations on the purchase of your new CK-303DMX Fogger. We are confident you will enjoy many
Trouble-free hours with this unit. To assist with the care and use of the product we have prepared this short

Guide.

Operation

Please check the unit immediately after unpacking. If find any damage or omitting parts, please do not use; and

Please contact your vendor.

Before connecting this unit to the mains for the first time you must first fill the fluid tank with fog fluid and check

That the nozzle is clean and unobstructed.

This fog machine has been designed to function on a main of either 120V~50/60Hz or 230V~50Hz and has
Been fitted with a suitable power plug for use with your local voltage. Check the label on the unit and th e power
Plug for the correct voltage.

Place the machine on a level surface and loosen the cap of the fluid tank to fill with quality unsc ented water
Based fog fluid. We recommend use of specially formulated fog fluid. Plug the remote control unit into the socket
At the rear and switch on to allow time to preheat. The remote control will be found at the rear of the unit. Simply
Remove the two thumb screws and remove from the unit. The cable is stored in the well. Once the machine has
reached temperature and is ready to operate the red light on the unit and the remote control will illuminate. Push
The button on the unit or the remote control when lit and hold for prolonged bursts of fog.

Always monitor fog fluid level as running the machine with no fluid could cause permanent damag e.

Please do not touch or place anything in close proximity to the nozzle during operation or preheat as there is a
Danger of burns.

Place the machine horizontally and loose the cap of liquid tank to pour the high quality fog liquid.

Put the plug of remote control box into outlet marked “control input” on CK-303DMX fogger rear panel.

Connect the machine with the proper power supply and ensure the unit is well grounded. When the red indicator
by the tank is ON, the fogger is heating up and not ready for work. When the green indicator by the tank is ON,
The fogger is ready. Press ON button in the remote controller, fog will keep bursting out. Release ON button in

The remote controller, fog bursting will stop.

Push up the button on the control box to burst when you need. You can push it many times until the green
Indicator LED is off.

Due to the high operating temperature of fog machines it is advised that the effect be used in well ventilated
Areas taking care not to obstruct the air vent. After use, allow time to 'cool' for safety before moving or touching.

never use any other type of liquid other than UNSCENTED water based fog fluid.
　 Use of any other fluids or additives will void the warranty.

Installation/Mounting

ZF-150DMX Fogger is for indoor use only. The place should be dry and cool. The fogger must be used in a

Horizontal position sitting on a level surface. In case put on ceiling or suspending, the degree of incline should
Be no more than 15 degree. Take care not to aim directly into anyone’s face.

Cleaning

Unplug unit before attempting to clean.

Cleaning your fogger regularly will help reduce costly parts replacement and repair charges. After every 40

Hours of continuous operation or when the machine will be idle for a long time it is recommended to run a

Cleaning solution composed of 80% distilled water and 20% white vinegar through the system to preve nt the
Accumulation of particles in the heating element.

1. While unit is unplugged and cool, unscrew nozzle at very front of unit and clean out debris with white

Vinegar and a pipe cleaner, making sure that the hole is free and unobstructed.

2. Empty all fog fluid from the machine and replace with cleaning solution in the tank. Plug unit in and allow it