Figure 3, OEM Unit Specifications..................................................................................11
Figure 4, OEM Unit Dimensions and Mounting Holes.....................................................11
Figure 5, SHoW DMX OEM Unit.....................................................................................12
Figure 6, SHoW DMX OEM Wiring.................................................................................13
Figure 7, the SHoW DMX OEM Receiver Controls.........................................................15
Figure 8, the SHoW DMX OEM Receiver Menus ...........................................................15
Figure 9, SHoW ID Table................................................................................................17
Figure 10, OEM User Interface Extension Dimensions...................................................18
Revision History
R0.10 Initial Draft Release
R0.11 Minor amendments
R0.12 Clarify power settings, application notes
R0.13 Add CE DoC
R1.0 Correct DIP SS, release for production
R1.1 Add OEM Extension PCB Information
R1.2 Add Compliance clarification
Rev 1.1 10/14/08
3 of 27 Pages
The SHoW DMX OEM Receiver User’s Manual
Radio Compliance Information
City Theatrical, Inc. # 5691 SHoW DMX Radio Transceiver
FCC ID: VU65691
IC ID: 7480A5691
City Theatrical, Inc. # 5692 SHoW DMX Radio Transceiver
FCC ID: VU65692
IC ID: 7480A5692
CE mark: CE1177
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Radio Frequency Notifications
FCC Notifications
RF Radiation The Product is an intentional radiator of Radio Frequency (RF) energy. In order to
limit RF exposure to personnel in the immediate area, the Product should be located and installed
such that a separation of at least 20 centimeters is maintained between the Product’s antenna
and personnel in the vicinity of the device.
Modification Warning
Caution: changes or modifications to this equipment, not expressly approved by City Theatrical
Inc. could void the user’s authority to operate the equipment.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that permitted for successful communication.
This device has been designed to operate with the antennas listed below, and having a
Rev 1.1 10/14/08
4 of 27 Pages
The SHoW DMX OEM Receiver User’s Manual
maximum gain of 5 dB. Antennas not included in this list or having a gain greater than
5 dB are strictly prohibited for use with this device. The required antenna impedance is
50 ohms.
Approved Antennas:
Manufacturer Model Type Connector Gain
1 Nearson S151AH-2450S Omni whip
2 Nearson S141AH-2450 Omni whip
3 Centurion WCP2400-MMCX4 Omni whip
CE Mark Conformity
City Theatrical Inc. declares that this product conforms to the specifications
listed in this manual, following the provisions of the European R&TTE directive
1999/5/EC:
City Theatrical Inc. vakuuttaa täten että dieses produkt tyyppinen laite on
direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien näiden direktiivien
muiden ehtojen mukainen.
City Theatrical Inc. déclare que le produit est conforme aux conditions
essentielles et aux dispositions relatives à la directive 1999/5/EC.
• EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment.
• EN 60950 Safety
• EN 300 328 Technical requirements for Radio equipment.
CAUTION—This equipment is intended to be used in all EU and EFTA countries.
Outdoor use may be restricted to certain frequencies and/or may require a license for
operation. Contact local Authority for procedure to follow.
Note: ESD precautions should be used when attaching or removing the antenna.
Note: Combinations of power levels and antennas resulting in a radiated power level of
Belgique Dans le cas d'une utilisation privée, à l'extérieur d'un bâtiment, au-dessus d'un espace
public, aucun enregistrement n'est nécessaire pour une distance de moins de 300m. Pour
une distance supérieure à 300m un enregistrement auprès de l'IBPT est requise. Pour une
utilisation publique à l'extérieur de bâtiments, une licence de l'IBPT est requise. Pour les
Rev 1.1 10/14/08
5 of 27 Pages
SMA plug reverse
polarity
SMA plug reverse
polarity
MMCX jack on 4” coax
pigtail
5dBi
2dBi
2.5dBi
The SHoW DMX OEM Receiver User’s Manual
enregistrements et licences, veuillez contacter l'IBPT.
France 2.4 GHz Bande : les canaux 10, 11, 12, 13 (2457, 2462, 2467, et 2472 MHz
respectivement) sont complétement libres d'utilisation en France (en utilisation
intérieur). Pour ce qui est des autres canaux, ils peuvent être soumis à autorisation selon
le départment. L'utilisation en extérieur est soumis à autorisation préalable et très
restreint. Vous pouvez contacter l'Autorité de Régulation des Télécommunications
(http://www.art-telecom.fr) pour de plus amples renseignements.
Rev 1.1 10/14/08
6 of 27 Pages
The SHoW DMX OEM Receiver User’s Manual
5692 SHoW DMX Radio CE Declaration of Conformity
Rev 1.1 10/14/08
7 of 27 Pages
The SHoW DMX OEM Receiver User’s Manual
System Compliance Information
All SHoW DMX Products are RoHS Compliant
Safety Notices
Please read this entire manual before using your new equipment. Please keep the
manual in a safe place so you can refer to it in the future as required.
The SHoW DMX System is intended for use only by qualified professionals. Connection,
installation and hanging of this equipment must be performed in accordance with all
pertinent local, regional and national safety codes and regulations.
SHoW DMX equipment is intended for indoor use only unless specified for outdoor use.
Keep the equipment dry! Do not operate the equipment if it gets wet!
Do not operate in excessive heat/direct sunlight.
Be sure installation provides adequate ventilation. Some system components can
produce significant heat and must be properly installed to allow proper cooling and
assure user safety. All sides of the equipment must be clear of obstruction and allow
free airflow.
There are no user-serviceable parts inside! Refer to qualified service personnel!
RF Exposure: The antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.
End-Use Compliance Certifications
City Theatrical # 5691 and 5692 Radios are fully compliant with the agency requirements
indicated by their certification markings when used in OEM applications, and are
approved for modular OEM use.
City Theatrical, Inc. # 5605 OEM Receivers are designed to meet North American safety
and emissions standards, however final compliance can only be confirmed after units
are correctly installed in the host hardware.
City Theatrical, Inc. # 5606 OEM Receivers are designed to meet North American and
CE safety and emissions standards, however final compliance can only be confirmed
after units are correctly installed in the host hardware.
OEM Applications of these City Theatrical Inc. products are not to be considered
compliant with agency requirements until the final OEM equipped products are tested
and certified separately for the applicable requirements.
End-use compliance testing and certification is the responsibility of the OEM user.
Rev 1.1 10/14/08
8 of 27 Pages
The SHoW DMX OEM Receiver User’s Manual
Markings
Radio compliance rules require that the following markings be placed on the final
assembly that the OEM Receivers are installed in.
These markings apply to the City Theatrical SHoW DMX Radio in this device