Citiwell 89365, 89367, 89366 User Manual

TROUBLE-SHOOTING

If at any time the camera unit or viewer/controller unit stops working, or works in an
unexpected fashion:

1. Check the condition of the AAA and AA batteries. If necessary, replace with fresh
batteries.

2. Check the battery condition icon on the viewing screen. If indicated remaining life is low,
please recharge the unit with the USB cord.

3. Turn both units off for 15 seconds and then turn them both back on. This will reset the
electronic systems in both units.

6+6+

For any other problems or concerns,
www.eyespytoys.com or call our Customer Assistance Line at 1866 469 9686

please contact us

via the EyeSpy website

© 2012 EyeSpy TM is a registered trademark of EyeSpy Toys Ltd. All rights reserved.
Manufactured for and distributed by Citiwell International Inc.
Conforms to the safety Requirements of ASTM F963 and EN-71(1).
WARNING! . Not suitable for children under 3 years of age due to small parts.
In an effort to continually improve our products, the items inside this package may vary slightly
from the photographs

9-401 Magnetic Drive, Toronto,Canada, M3J 3H9
Customer Care:1866 469 9686

MADE IN CHINA
PRINTED IN CHINA

www.eyespytoys.com

Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly. • If at any time in
the future you should need to dispose of this product please note that Waste Electrical Products should
NOT be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive).

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

- Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

surveillance technology

INSTRUCTION GUIDE

www.eyespytoys.com

The EyeSpy™ Xplorer is a super-tough go-anywhere, radio-

controlled, audio-video spy vehicle for observing in real time with full

color. It consists of a tracked vehicle and a controller/viewer.

Add SD Card

KEY FEATURES

Xplorer:

– With its rugged rubber tracks – like those of a bulldozer or a tank – the Xplorer vehicle can go
almost anywhere, carrying its color camera on board and sending back images to the viewing
screen unit atop the remote control.

USB Cord :

- The USB cord is used to charge the viewer’s lithium-polymer rechargeable battery, and
connects the viewer to the USB port that is commonly found on most computers.

Viewer:

- This hand-held viewer lets you see images being sent by the camera. You can watch live
action views, record snapshots or movies (saved to a user-supplied SD memory card), review
pictures and movies that you have created, and set the camera to record a movie after a pre-set
delay of between one and five minutes.

Remote Control:

- The simple controls allow you to steer the xplorer easily. The camera angle can also be
adjusted remotely.

CONTENTS LIST AND PARTS IDENTIFICATION

To record a movie, press the Select button (check mark).
corner of the screen will begin to flash on and off and a timer will appear that shows the
duration of the movie. To stop the recording, press the button with the Back button
(up-arrow).You can also instantly start a recording by pressing the large round button on top
of the camera.

REVIEW – When you choose this screen option and press the check mark button, you will
be given the choice of reviewing any photos or movies you have taken. The SD memory
card containing the photos or movies must be inserted in the viewer to use this function.
Once you choose to review either photos or movies you will be shown a list of the items
stored on the SD memory card. Move the cursor down with the down buttons. Press the
check mark button to choose which item you wish to review. Press the up-arrow button to
return to the item choice menu. Press the up-arrow again to return to the main screen menu.

TIMER – Use the Next button (down-arrow) to choose the timer function, then press the
Select button (check-mark). A timer display is shown and you are given the choice of adding
time or confirming your choice (OK). The timer display will increase by one minute every
time you choose to “Add Time”, up to a maximum of 5 minutes. If you continue pushing the
Select button the timer display will return to “00:01” (one minute). Choosing “OK” will start
the countdown to “00:00.” Movie recording will then start, and will continue for 90 seconds.
The timer will then begin the countdown again, using the preselected time. Another 90
second movie will be recorded. This will continue until the user-installed SD memory card is
full. The number of movies you can record and save will depend on the memory capacityof
the SD card you are using.

DELETE – Choosing this function and pressing the check-mark button lets you delete any
photo or movie by choosing it and then pressing the check-mark button. You will be asked
to confirm your choice by pressing the check-mark button again. Choices are also available
to delete all photos or all movies at once.

The red dot in the upper right

USB Cable

Xplorer Viewer

VIEWER BATTERY RECHARGING

Antenna

Remote Control

Some function screens will show a battery icon in the upper left hand corner of the screen.
As battery power is used the bars that make up the battery icon will disappear one by one.
When the lithium-polymer battery needs to be recharged a “Battery Low” icon will briefly
appear and the battery icon will turn red and flash on and off several times.

Attach the USB cord and connect the viewer to a computer’s USB port as described in the
above section “GETTING STARTED.”

1. 6.