Gozinta
User Manual
Gozinta Description
The Gozinta is an input module capable of amplifying line level signals to Eurorack levels. The
2 independent channels have nominal 24dB gain and include front panel attenuators. Ultramodern amplifier ICs give this module excellent performance characteristics. Clip LEDs show
when output levels are about to clip.
The module can also be used as a utility amplifier for situations where processing has produced
low levels, such as when using a filter for percussion.
Also the module has good sharp clipping characteristics and produces interesting distortion
effects.
There are gain setting jumpers for each channel to configure gain to 12, 24, or 36dB. The
amplifiers are AC-coupled and are jumper selectable to DC
operation on each channel.
The Gozinta uses high performance LM4562 amplifiers which have excellent noise and
distortion specs, one of the best amplifiers available today. The Gozinta also boasts sealed
pots and enclosed jacks. No scratchy controls!
Examples:
Boosting levels of external equipment such
as MP3 players, CD players, computer
sound card outputs, and rack gear like
reverb units
Make-up amplifier for signals that are low
from processing or from patch issues like
low VCA output
When using a signal as a gate or clock but
the level is too low
Produces a clean distortion sound when
overloaded
This 4HP module has a maximum 20mA current
draw.
Front Panel Interface:
Gozinta
Level 1 & 2: Adjusts the gain of their respective channels, from 0 to max gain
In 1 & 2: Inputs for each amplifier
Out 1 & 2: Outputs for each amplifier
Clip LEDs: Shows when the amplifiers have reached maximum output
Jumper locations – Gozinta Rev B
Power connector
Place jumper here for
DC operation (LFO
s, etc)
Max gain jumpers:
Channel 1 jumpers
Channel
2
jumpers
‘low’ for 12dB gain
‘med’ for 24dB gain
No jumper for 36dB gain
Jumper locations – Gozinta Rev A
Power connector
Place jumper here for
Max gain jumpers:
Channel 1 jumpers
Channel
2
jumpers
Place jumper here for
‘low’ for 12dB gain
‘med’ for 24dB gain
No jumper for 36dB gain
Channel 1 DC operation
(LFOs, etc)
Channel 2 DC operation
(LFOs, etc)
Module Width 4HP (20mm)
Module Depth 37mm
Power Connector Standard Doepfer 16 pin
Power Requirements ± 12 Volts at 20mA Max
Input Impedance 20K Ohms
Output Short circuit protected
Loading...