CIG OAPDBNA User Manual

WF-3220-Z1 User Manual

WF-3220-Z1

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into and outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Any special accessories needed for compliance must be specified in the instruction manual.

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

The minimum distance between this equipment and user should be 40 cm when the equipment operates.

History Version Version Author Time Remarks

Format

Definition

Preface

This manual mainly introduces how to configure the WF-3220-Z1 to users when they install AP device. It’s suggested to read this guide carefully before install the WF-3220-Z1. This part includes the follow contents:

 Content introduction  Readers  Conventions



Content introduction

This document introduces WEB configuration, CLI confuguration and WEB upgrade. It is divided into six chapters.

 Chapter 1 Product Introduction  Chapter 2 WEB Configuration and Management

WF-3220-Z1

 Chapter 3 CLI Configuration  Chapter 4 Change AP Working Mode  Chapter 5 Common Operation in Fat AP Mode  Chapter 6 Upgrade



Readers

This document is for readers as followss:

 FAE and technical support  Network manager



Convention of symbols in this manual

<> Characters in <> means this is a button, such as < OK> [ ]

Characters in[ ] means this is a window, menu or a datasheet, like popup a [new user] window. Multilevel menu will use “/” to separate, such as [File/New/Folder], that means choose folder in the multilevel menu File/ New

This document adopts the following symbols to inform readers of special attention when they are operating the device. Notes and tips in the body of manual will be shown in Times New Roman fonts, and separated from surround contents with a horizontal line as followss:



 TIP:



Means a complementary description

Caution：：：：

Means reader be careful. Improper operation may cause data loss or damage to equipment.

Professinal installation:

The device cannot be sold retail, to the general public or by mail order. It must be sold to dealers. It is installed by licensed professionals with special training according to Installation instruction provided by dealer or grantee.

WF-3220-Z1

Contents

1 PRODUCT INTRODUCTION ....................................................................................... 1

2 WEB CONFIGURATION AND MANAGEMENT .......................................................... 2

2.1 NETWORK SETTINGS ......................................................................................... 2

2.1.1 WAN INTERFACE NETWORK SETTINGS ................................................... 2

2.1.2 WIRELESS NETWORK SETTINGS .............................................................. 3

2.2 LOG ON ................................................................................................................. 4

2.3 SYSTEM STATUS ................................................................................................. 4

2.4 WIRELESS SETTINGS ......................................................................................... 4

WF-3220-Z1

2.4.1 WIRELESS STATUS ..................................................................................... 4

2.4.2 VAP SETTINGS ............................................................................................. 4

2.4.3 ADVANCED SETTINGS ................................................................................ 5

2.4.4 MULTI SSID-VLAN BINDING ........................................................................ 5

2.5 TCP/IP SETTINGS ................................................................................................ 6

2.5.1 LAN STATUS ................................................................................................. 6

2.5.2 LAN SETTING ................................................................................................ 6

2.6 DEVICE MANAGEMENT ...................................................................................... 6

2.6.1 TIME SETTING .............................................................................................. 6

2.6.2 SYSTEM LOG ................................................................................................ 6

2.6.3 FIRMWARE UPGRADE ................................................................................. 6

2.6.4 CONFIGURATION BACKUP AND RESTORE .............................................. 6

2.6.5 USER MANAGEMENT .................................................................................. 6

3 CLI CONFIGURATION ................................................................................................. 6

3.1 ENTERING CLI...................................................................................................... 7

3.1.1 TELNET BY DOS INTERFACE ..................................................................... 7

3.1.2 LOGIN THROUGH RS 232 CONSOLE PORT .............................................. 7

3.1.3 LOGIN BY SECURECRT TOOL .................................................................... 8

3.2 CLI COMMANDS ................................................................................................... 9

3.2.1 IFCONFIG ...................................................................................................... 9

3.2.2 IWCONFIG ................................................................................................... 10

3.2.3 IWPRIV ......................................................................................................... 12

3.2.4 WLANCONFIG ............................................................................................. 14

3.2.5 IWLIST.......................................................................................................... 15

3.2.6 SYNTHESIS INSTANCE .............................................................................. 16

4 CHANGE AP WORKING MODE ................................................................................ 16

WF-3220-Z1

4.1 OPERATING THROUGH WEB UI ...................................................................... 16

4.2 OPERATING THROUGH SERIAL PORT ........................................................... 16

5 COMMON OPERATION IN FAT AP MODE .............................................................. 17

5.1 CHECK AP INFORMATION ................................................................................ 17

5.2 CREATE VAP ...................................................................................................... 17

5.3 MODIFY WIRELESS PARAMETERS ................................................................. 18

5.4 CHECK AND MODIFY PARAMETERS .............................................................. 18

5.5 CHECK AND MODIFY VAP CHANNEL .............................................................. 19

5.6 CHECK AND MODIFY OUTPUT POWER .......................................................... 19

5.7 SAVE CONFIGURATION .................................................................................... 19

5.8 BACKUP CONFIGURATION TO LOCAL PC ..................................................... 19

5.9 FACTORY DEFAULT .......................................................................................... 20

5.10 SOFTWARE MIRROR ......................................................................................... 20

5.10.1 MIRRORING DESCRIPTION ..................................................................... 20

6 UPGRADE .................................................................................................................. 20

6.1 CONNECT AP CORRECTLY .............................................................................. 20

WF-3220-Z1

6.2 SET IP FOR COMPUTER ................................................................................... 21

6.3 LOGIN AP ............................................................................................................ 21

6.4 FIRMWARE UPGRADE ...................................................................................... 21

6.5 CHECKING .......................................................................................................... 22

WF-3220-Z1

Contents of Figure

Figure 1-1 Product Appearance ........................................................................................................ 1

Figure 2-1 ping default IP of AP ........................................................................................................ 3

Figure 3-1 DOC interface .................................................................................................................. 7

Figure 3-2 Telnet management interface .......................................................................................... 7

Figure 3-3 Startup information of AP ................................................................................................. 8

Figure 3-4 Logining interface ............................................................................................................. 8

Figure 3-5 wlanconfig instance ........................................................................................................ 15

Figure 3-6 Synthesis Instance ......................................................................................................... 16

Figure 4-1 Setting AP mode through serial port .............................................................................. 17

Figure 5-1 Check AP version ........................................................................................................... 17

Figure 5-2 Check VAP mode ........................................................................................................... 18

Figure 5-3 Check VAP Channel ...................................................................................................... 19

Figure 5-4 Check Output Power of VAP .......................................................................................... 19

Figure 6-1 Connect AP .................................................................................................................... 21

Figure 6-2 PoE port of AP ............................................................................................................... 21

Contents of Table

Table 2-1 Default Configuration of AP ............................................................................................... 4

Table 3-1 Default Configuration of AP ............................................................................................... 6

Table 3-2 Necessary software tool .................................................................................................... 7

Table 3-3 Hyper Terminal parameters .............................................................................................. 8

Table 3-4 CLI Commands Overview List ........................................................................................... 9

WF-3220-Z1

Items

Description

Product Introduction

Figure 1-1 Product Appearance

WF-3220-Z1 is an 11n access point with high power and double frequency. Compared with traditional 54Mbps 11G and 108Mbps Super G products, WF-3220-Z1 provides a rate of 300Mbps. With such high bandwidth, it highly enhances data transmission’s effectiveness and reduces network delay in voice and video processing, network game playing, and video-on-line selecting. Double frequency design satisfies the application needs of 2.4 GHz and 5.8GHz. With a gain planar antenna, WF-3220-Z1 highly enhances wireless reception and emission capacity, ensuring wireless signal’s stability. The adoption of WPA/WPA2 and WEP security mechanism provides an overall safeguard for wireless network. WF-3220-Z1 is a newly developed comprehensive access point, which can be used to receive WiFi signal, cover wireless signal, and amplify signal. Meanwhile it can also work together with AC to realize a centralized management.

Hardware Specification

WLAN

Interface

IEEE802.11a/b/g/n(2*2:2)；Speed up to 300Mbit/s 10/100/1000M Ethernet Interface；Console Interface （for manufacture use only）；4 x N Female Interface (2 interface for 2.4GHz band and 2 interface for 5GHz band)；GND Earth Terminal；

2.4GHz band Directional Model: KBT65DP15-24RT0

dedicated MIMO antenna 5GHz band Directional

Model: TDJ-5158GAx2

dedicated MIMO antenna Indicator One Power Indicator

+ 21 hidden pages

CIG OAPDBNA User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual