CIG 140W User Manual

G-140W-C

User Manual

1 Precautions

Please read the user manual before installation and operation of the

device. Please keep the User Manual for future reference.

1.1 Installation Precautions

 The device should only be installed by qualified personnel.
 Please check the voltage rating before connecting the power. It is

recommended not to share the same power socket with other high
power-rated devices (examples: Hairdryer, Refrigerator, Iron).

 Do not place the device in the vicinity of flammable or conductive

materials, high temperature (direct sunlight), moisture, or other
appliances that produce heat.

 Always make sure the device is properly ventilated, do not place

any objects on the device to avoid overheating.

 Ensure the device is installed on an even surface.
 The power socket and power cable shall be inspected regularly

and replaced in case ofdamage to avoid risk of electric shock or
fire.

1.2 Operation Precautions

 Do not attempt to repair the device in any occasion. Improper

disassembly of the device may expose you to electric components
and may cause shock or other risks. Please contact your service
provider if there are problems with the device.

 Unplug the power before cleaning equipment. Use a soft and dry

cloth to clean the equipment.Avoid the use of liquid or aerosol.

 Prevent liquid spillage on the device to avoid short circuit.
 Ensure a proper environment for the device to avoid overheating;

do not block the device ventilation outlet.

 Please contact the Service Provider if you are in doubt in on how

to connectother electronic devices to the ONT to avoid possible
damage to the devices.

- 1 -

1.3 Laser Safety

Only qualified service personnel who are extremely familiar with laser
radiation hazards should install or remove the fiber optic cables and
fiber related units in this system.

There may be invisible laser radiation at the fiber optic cable when the
cable is removed from the connector. Avoid direct exposure to the laser
beam

Notethe following danger with regards to laser safety: Eyes can be
damaged when they are exposed to a laser beam. Take necessary
precautions before you plug in the optical modules.

Do not bend the cables to a diameter of less than 7.5 cm as this may
damage the fiber or reducethe normal optical signal strength.

The ONT is classified as a Class 1 laser product based on its transmit
optical output.

- 2 -