Chungear Co CE9603 User Manual

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT
KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.

IMPORTANT

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e.
existing wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or
ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.

7. Do not install in damp locations or immerse in water. (For indoor use only.)

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking
takes place as this will damage the transmitter. Dispose of used battery properly, and keep
the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any
variable (rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the

“Light Switch” after installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket.

The canopy comes up to cover the receiver and bracket.

LEARNING PROCESS

1. This unit finished learning process inside manufactory, if replace transmitter or receiver, user

need to redo learning process before using this unit. Receiver could remember up to 5pcs
transmitter.

2. After installing the unit and power on, open battery cover (with battery, DC12V/A23 1pc,

installed) and press and use a ball pen to hold ”LEARNING” key 1~3seconds, FAN will be turn
off and the turn to medium speed, which indicate that learning process finished. Learning effect
distance is same with remote’s. Please note that must press the “LEARNING KEY” within
30sensonds after power on. If just replace batteries, no need to re-learn.

3. Please note that the transmitter can learn in multiple receiver, when doing learning process

please make sure not learn in other receiver. Suggest to separate power switches of fans in 2
meter range.

DIMMER

LEARNING KEY

LEARN

LIGHT FUNCTION
SELECT SWITCH

OFF

LIGHT FUNCTION SELECT SWITCH

1. If installed energy light onto ceiling fan, please slide the “light function select switch” to on/off

position. If installed tungsten light onto ceiling fan, please slide the “light function select switch”
to dimmer position.

2. Light load: 190W (Max.) If overload, the receiver will cut off light power automatically. Please change

the light load.

FUNCTIONS OF TRANSMITTER

TRANSMITTER

0 : Turn off the fan.
。 : Turn on the fan at low speed.
。。: Turn on the fan at medium speed
。。。 : Turn on the fan at high speed

LIGHT:

ON/OFF - Press and release immediately to turn on or off the light

DIMMER- Press and hold to dim or brighten lights to the desired

level and release. (Only for the tungsten bulb.)

.