Chungear Co CE10710 User Manual
Model # TR190C+JY1055(with light function)
40W
(Max.)
for
motor
and
30W
(Max.)
for
LED
light
.
Important
:
Using
a
full
range
dimmer
switch
(not
included)
to
control
fan
speed
will
damage
the
fan.Toreduce
the
riskoffireorelectrical
shock,
do
not
useafull
range
dimmer
switch
to
control
1.
Switch
power
offatfuse
boxorcircuit
breaker
before
you
Make
wiring
connections
as
indicated
Fig.
1.
Launch
distance
for
remote
control:
about
10m.
pc
a
the
.
previously
darkness
DC POWER CEILING FAN REMOTE CONTROL MANUAL
□INSTALLATION INSTRUCTIONS
NOTE:
fan and in an AC120V 60Hz power supply only. Output Power:
fan speed.
2.
3.
4.
This unit is to be used for the control of DC power ceiling
begin installing the fan.
The remote code setting process:
Step: 1 Open the remote battery cover and install DC12V,A23 1
alkaline battery, with the fan power off. (Fig. 2)
Step: 2. Within 30 seconds of restring power to the fan, you must use
ball pen or tool to press “Learn” button about 2 seconds. Once
receiver has detected the frequency, the ceiling fan light will turn on, then off
This will indicate the receiver has learned the frequency that was
selected on the transmitter.
Note: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing so
will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not
responding to the transmitter, please turn the power off to the receiver. And repeat step 2.
If you want to clear before learned transmitter, hold the “Learn” button about 12 seconds. The ceiling fan light will
flash twice.
Fig. 1
□FUCNCTIONS OF REMOTE CONTROL: (Fig. 3)
Fig. 2
The receiver will make bi sound when light is dim for the brightness or
level.
When the battery is low power, press any button and LED light would be flash about 2 seconds. Please change
and use new battery.
TR190C
To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority
to operate the equipment.
FCC ID：KUJCE10710
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Loading...