Chungear Co CE10616 User Manual

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT

KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e.

existing wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or

ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC120V 60Hz power supply only.

7. Do not install in damp locations or immerse in water. (For indoor use only.)

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes

place as this will damage the transmitter. Dispose of used battery properly, and keep the

battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any

variable (rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light

Switch” after installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket.

The canopy comes up to cover the receiver and bracket.

LEARNING PROCESS

1. This unit finished learning process inside manufactory, if replace transmitter or receiver, user need to

redo learning process before using this unit. Receiver could remember up to 5pcs transmitter.

2. After installing the unit and power on, open battery cover (with battery, DC1.5V/AAA 2pcs, installed) and

press and use a ball pen to hold ”LEARNING” key 1~3seconds, FAN will be turn off and the turn to

medium speed, which indicate that learning process finished. Learning effect distance is same with

remote’s. Please note that must press the “LEARNING KEY” within 30sensonds after power on. If just

replace batteries, no need to re-learn.

3. Please note that the transmitter can learn in multiple receiver, when doing learning process please make

sure not learn in other receiver. Suggest to separate power switches of fans in 2 meter range.

LIGHT FUNCTION

SELECT SWITCH

LEARNING KEY

LIGHT FUNCTION SELECT SWITCH

1. If installed energy light onto ceiling fan, please slide the “light function select switch” to on/off

position. If installed tungsten light onto ceiling fan, please slide the “light function select switch”

to dimmer position.

2.

Light load: 190W (Max.) If overload, the receiver will cut off light power automatically. Please change the

light load.

TRANSMITTER

FUNCTIONS OF TRANSMITTER

LIGHT : Press and release immediately to turn on or off the light.

When light function select switch is on dimmer position, function keys

are changed. Press and hold to dim or brighten light to the desired

level and release.

OFF : Turn off the ceiling fan.

HI :Turn on the fan at high speed

MED :Turn on the fan at medium speed

LOW : Turn on the fan at low speed

L. LOW :

Turn on the fan at lower speed

TR92B

Installation of Transmitter

Wall Mount Holder with two

screws.