Chungear Co CE10606 User Manual

WALL/COOLTOUCH TRANSMITTER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND THE LIGHT KIT

TO THE ON POSITION BEFORE INSTALLING THE REMOTE CONTROL.

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e. existing
wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC110/120V 60Hz power supply only.

7. The receiver is acceptable for installation in damp and wet rated fans, but cannot be submerged in
water. The wall transmitter is only to be installed indoors.

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place
as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable
(rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WILL DAMAGE THIS RECEIVER.

1. Ceiling fan must be set at HIGH speed before installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The
canopy comes up to cover the receiver and bracket.

AC POWER ON/OFF SWITCH( ): Before installing wall control, slide to “OFF” position. After

installation is complete, slide to “ON” position to begin operation.

Installing Wall Control (TRANSMITTER):

Remove wall plate, disconnect and remove the toggle switch

from wall junction box. Using the wire connectors,

make the electrical connections to the wall control

(transmitter) unit. Carefully push all connected wires

inside wall switch box. Secure wall control unit with

2 screws previously removed. Face plate will snap

onto the transmitter.

ACTIVATING THE LEARNING PROCESS

Note: The Wall Transmitter will need to be programmed first before the hand held remote.

1. After installation is complete, AC power is turned on and

SWITCH is at ON position within 30 seconds,

press and hold the LEARN button for 3 seconds. Fan will

turn on at medium speed and light (if installed) will turn

on. This confirms that the SMART SYNC setting is active

and ok. (FIG. 4)

2. If user cannot finish the setting within the 30 seconds

time frame, the main power must be turned off and

re-started again. This will reset the unit. Repeat step 1

until the LEARNING feature is activated as indicated.

LIGHT FUNCTION SELECT SWITCH

1. If the ceiling fan has fluorescent lighting, please slide the “light function select switch” to “O” position. If

the ceiling fan has incandescent or halogen lighting or LED, please slide the “light function select

switch” to “D” position. (FIG. 4)

2. Light load: 190W (Max.) If overloaded, the receiver will cut off light power automatically. Please change

the light load.

FIG. 4

WALL TRANSMITTER OPERATION (FIG. 5)

FAN OFF :Turn off the ceiling fan.

HI : Turn on the fan at high speed.

MED : Turn on the fan at medium speed.

LOW: Turn on the fan at low speed.

LIGHT: ON/OFF-Turn the light on or off.

DIMMER-Press and hold to dim or

brighten light to the desired level and release.

(Incandescent or halogen or LED and light function select switch Or on “D” position.)

REV: Press this button for forward/reverse airflow of ceiling fan. (Optional)

TR269A

FIG. 5