Chungear Co CE10602 User Manual

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND THE LIGHT KIT

TO THE ON POSITION BEFORE INSTALLING THE REMOTE CONTROL.

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall
switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC110/120V 60Hz power supply only.

7. The receiver is acceptable for installation in damp and wet rated fans, but cannot be submerged in water.
The wall transmitter is only to be installed indoors.

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as
this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable
(rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WILL DAMAGE THIS RECEIVER.

1. Ceiling fan must be set at HIGH speed before installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy
comes up to cover the receiver and bracket. (FIG 1)

FIG. 1

HANDSET TRANSMITTER OPERATION

the

FIG. 2

Activating the Learning process: Turn on the receiver

power, press and hold the LEARN key (on the back of

transmitter) for 1~3S. Refer to FIG. 2

Light (if installed) will flash twice and off. This confirms

that the learing setting is active and ok.

Transmitter use 2 pcs AAA/1.5V batteries.

Light

function

select switch

LEARN key

LIGHT FUNCTION SELECT SWITCH

If the ceiling fan has fluorescent lighting, please slide the

“light function select switch” to “O” position. If the ceiling

fan has incandescent, halogen lighting or dimmerable LED, please slide the “light function select switch” to “D”

position. (FIG. 2)

FUNCTIONS:

:Turn off the ceiling fan.

: Turn on the fan at high speed.

: Turn on the fan at medium speed.

: Turn on the fan at low speed.

: Turn on the fan at lower speed.

: The fan will turn off after 2 hours automatically.

: The fan will turn off after 4 hours automatically.

: The fan will turn off after 6 hours automatically.

:

ON/OFF-Turn the light on or off.

DIMMER-Press and hold to dim or brighten light to the desired level

and release.

(Incandescent or halogen or dimmerable LED only and light function select switch on “D” position.)