Chungear Co CE10206 User Manual

CEILING FAN REMOTE CONTROLLER

OPERA TION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT
(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.

IMPORTANT

IMPORTANT POINTS TO REMEMBER:

1.Read and save these instructions.

2.Please note that all fixed wiring appliances should be installed by a qualified electrician.

3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall
switch.

4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6.This unit is to be used for the control of ceiling fan and in a AC110/120V 60Hz power supply only.

7.Do not install in damp locations or immerse in water. (For indoor use only.)

8.Do not pull on or cut leads shorter.

9.Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place

as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable

(rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

1.Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch”
after installation.

2.Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy
comes up to cover the receiver and bracket.

CODE SWITCH

MODEL:E01BT-S

1.CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code used
for both transmitter and receiver is exactly the same, otherwise remote controller will not work. Please
note the code switch will enable you to operate a second remote controller independently. For example, if
you have two ceiling fans with 2 remote control units, set 2 different codes for each set of
transmitter/receivers. This means you can operate each ceiling fan independently.

2.Your remote control is ready for use after battery installation.

TRANSMITTER

FUNCTIONS OF TRANSMITTER

OFF: Turn off the fan.
HI : Turn on the fan at high speed.
MED:Turn on the fan at medium speed
LOW: Turn on the fan at low speed
LIGHT ON/OFF: turn on or off the light.
DIMMER: Press and hold to dim lights.

Ceiling Fan Remote

Control

Wiring Connection

Installation of Transmitter
Wall Mount Holder with
two screws.