Chungear Co CE10201 User Manual

CEILING FAN REMOTE CONTROLLER

OPERA TION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT
(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.

IMPORTANT

IMPORTANT POINTS TO REMEMBER:

1.Read and save these instructions.

2.Please note that all fixed wiring appliances should be installed by a qualified electrician.

3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall
switch.

4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6.This unit is to be used for the control of ceiling fan and in a AC110/120V 60Hz power supply only.

7.Do not install in damp locations or immerse in water. (For indoor use only.)

8.Do not pull on or cut leads shorter.

9.Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place

as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable

(rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

1.Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch”
after installation.

2.Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy
comes up to cover the receiver and bracket.

BLACK

AC POWER SUPPLY

WHITE

(Mains/Neutral)

ANTENNA

(Leave unconnected and
do not cut)

(Mains/Live)

VIEW AFTER INSTALLATION

BLUE

(Light/Live)

WHITE

(Fan/Neutral)

ANTENNA

BLACK

BLACK

(Fan/Live)

CODE SWITCH

1.CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code used
for both transmitter and receiver is exactly the same, otherwise remote controller will not work. Please
note the code switch will enable you to operate a second remote controller independently. For example, if
you have two ceiling fans with 2 remote control units, set 2 different codes for each set
of transmitter/receivers. This means you can operate each ceiling fan
independently.

2.Your remote control is ready for use after battery installation.

FUNCTIONS OF TRANSMITTER

: Turn off the fan.

3 : Turn on the fan at high speed

2 : Turn on the fan at medium speed
1 : Turn on the fan at low speed.

LIGHT:

ON/OFF - Press and release immediately to turn on or off the light

DIMMER- Press and hold to dim or brighten lights to the desired level and

release. (Only for the tungsten bulb.)

ON DIP

DIP SWITCH

TRANSMITTER

4321

If light load over 190W, light will shut down.

BLACK

L

WHITE

N

AC POWER INPUT

ANTENNA

Ceiling Fan Remote Control

Wiring Connection

TO FAN / LIGHT / NEUTRAL
TO FAN/LIVE
TO LIGHT LIVE

MODEL:MR101F

MODEL:TR158A

WHITE

BLACK

BLUE

FAN MOTOR