Chungear Co CE10007 User Manual

CEILING FAN REMOTE CONTROLLER

OPERA TION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT
(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.

IMPORTANT

IMPORTANT POINTS TO REMEMBER:

1.Read and save these instructions.

2.Please note that all fixed wiring appliances should be installed by a qualified electrician.

3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall
switch.

4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6.This unit is to be used for the control of ceiling fan and in a AC110/120V 60Hz power supply only.

7.Do not install in damp locations or immerse in water. (For indoor use only.)

8.Do not pull on or cut leads shorter.

9.Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place

as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable

(rheostat) wall control.

INSTALLATION INSTRUCTIONS

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

1.Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch”
after installation.

2.Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy
comes up to cover the receiver and bracket.

MODEL:TR110A

FUNCTIONS OF TRANSMITTER

OFF:Turn off the fan.
HI:Turn on the fan at high speed.
MED:Turn on the fan at medium speed
LOW:Turn on the fan at low speed

F/R:Turn on the fan at FOR OR REV state

UP LIGHT

FAN OFF

LOW

F/R

UP&DOWN LIGHT: Press and release immediately to turn on or off the light.

Press and hold to dim or brighten lights to the desired

level and release. (Only for the tungsten bulb.).

Ceiling Fan Remote Control

Wiring Connection

DOWN LIGHT

MED

HI

Installation of Transmitter
Wall Mount Holder with
two screws.