Chuangwei RGB Electronics NTUDU8 User Manual

Shenzhen skyworth RGB electronic co., LTD.

Model: NTUD-U8

Operation Instruction

Respect of customer, sincerely thank you for purchasing

SKYWORTH equipped with wireless WIFI NTUD-U8 type USB

peripheral products.

This product can support USB2.0 protocol, based on the

IEEE802.11 b/g/n and BT5.0 standard design. With all the way

to send and receive all the way (2T2R) dual channel work,

maximum transmission rate of up to 300 Mbps. Ensure that

users browse and download data flow, security and stability.

NTUD – U8 wireless WIFI USB peripheral product support

Windows XP/Vista / 7 / Linux operating system. In SKYWORTH

TV, have complete embedded in the product and the driver,

without user to install, and at the same time support Linux and

Android.

Used in TV production operation is as follows:

1. Turn on the TV, switch to the "home page" interface.

2. Select "Settings" feature. "OK" to enter

3. Select "network setup" function. "OK" to enter;

4. Choose the "wireless network", "OK" to enter;

5. According to the needs, select "auto search", "manual

connection", etc. Press the "OK" to enter

6. Choose their own after the AP name "OK" to enter, Enter the

password.

Television system has the memory function, for the first time

to use should be according to the above steps, later need not

operation, boot automatically connected. If need to change the

AP or change the mode of connection, need according to the

above steps again.

Note: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

- Consult the dealer or an experienced radio/television technician for
help.

To assure continued compliance, any changes or

modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate this

equipment.

Regulation information

(1) List of applicable FCC rules:

a. FCC Part 15.247
b. FCC Part 15.249

(2) Summarize the specific operational use conditions:

This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter. The host product
manufacturer should state this information to the host instruction manual.

(3) Limited module procedures:

Not applicable.

(4) Trace antenna designs:

Not applicable.