Christie Phoenix Quad-t User Manual

Open a browser and browse to the IP address displayed is displayed.

Default user name: service

Phoenix Quad-T Quick Start

What you will need

 One CAT 5E or CAT-6 Ethernet cable  A device with a web browser  Up to 4 HDMI cables  Phoenix system  Managed network configured to support multicast streaming  Power  Optionally for reachback control, up to 4 mini USB to USB-A cables

Set up the unit.

1. Connect video so urces to Input 1-4.

2. Optionally, set up the connectors for reachback control (KVM1 is used for the source connected to Input 1, KMV2 for the source connected to Input 2, etc.).

3. Connect the unit to a network.

4. Connect the power cable. Connect the 4-pin power cable to the back of the unit.

5. Power on the unit. Press the power switch. When the unit is ready for use,

6. Connect a browser-enabled

7. Connect to the Phoenix Quad-T

8. Log in.

Confirm the network has a managed network switch and that it has been configured to support

multicast streaming

device (for example, laptop) to the same network as the unit.

Web Manager.

Connect one end of the HDMI cable to the device and

the other end to the source.

• Connect a mini USB connector to the KVM port on the Quad-T.

• Connect the USB-A end to the source.

Connect one end of a Ethernet cable to the Network connector on the unit and connect the other end to the managed network.

Connect the other end to a power source.

the IP address of the unit is displayed on the front panel.

Contact your system administrator if needed.

on the front panel. The login page for the web manager

Default password: service Change the default settings using the Sys tem Setting s

page.

Phoenix Quad-T Quick Start 1 020-000879-02 Rev. 1 (08-2017)

Phoenix Quad-T Quick Start

• Multicast addresses must conform to the following:

requirements.

2. Update the firmware.

3. Configure the Encoder sources using the Phoenix Quad-T Web Manager.

Obtain the latest firmware file from the Christie web site. Use the System Settings page in the Quad-T Web Manager to update the firmware.

Use the E1, E2, E3, and E4 pages in the Phoenix Quad-T Web Manager to configure the encoder sources connected to Input 1-4. Each source is configured on the web page related to the physical connector (for example, E1 is used to configure the source connec te d to HDMI 1).

 Must be valid ate d fo r channe ls and acro s s units  Must be approv ed for use on the network  Cannot conflict with other Quad-T units or other devices

• Audio can be enabled

• Bit rate can be adjusted to align with the bandwidth or quality

4. Add the Phoenix Quad-T to your Phoenix s ystem as a RTSP source.

Select QUADT as the Protocol Type.

Learn More This is a Quick Start Guide. See the Phoenix Quad-T User M anual (020-101771-nn) for more detail s. Christie Technical Support For support, call 1-800-221-8025 (option 3) or em ail: Tech-Support@Christiedigital.com

Phoenix Quad-T Quick Start 2 020-000879-02 Rev. 1 (08-2017)