Chord VGW1, VGW1 171.848UK User Manual

VGW1

VHF GUITAR WIRELESS SYSTEM

Item ref: 171.848UK

User Manual

171.848UK User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

Thank you for choosing the Chord VGW1 guitar wireless system. This professional wireless set provides a high quality
VHF guitar system for freedom of movement without loss of audio quality. Please read this manual before using this
equipment in order to avoid damage through incorrect operation and to get the best performance from your purchase.

Contents:

Please take care when unpacking this product. Inspect for any damage and ensure you have the following components…

 VHF wireless receiver
 Mains power adaptor
 6.3mm mono output jack lead
 9V battery, PP3
 6.3mm to 3.5mm guitar to bodypack lead

Warning

To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by qualified
personnel before further use.
Avoid impact or heavy vibration to any of the components.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.

Safety

 Use the power adaptor supplied or an appropriate replacement with the same specification.
 Avoid ingress of water or particles into the transmitter or receiver
 Use alkaline or NiMH batteries in the transmitter and remove if unused for long periods.
 Observe the correct polarity when replacing batteries

Placement

 Keep all components out of direct sunlight and away from heat sources.
 Do not place heavy objects on top of the receiver or transmitter
 If rack-mounting, secure the receiver to a 1U rack tray and do not place heavy equipment above the receiver.
 Keep the transmitter and receiver away from damp or dusty environments.

Cleaning

 Use a soft cloth with a neutral detergent to clean the body of the transmitter and receiver.
 To avoid damage, do not use solvents to clean the components