Chord U-SERIES, UH1, UH2, UN1, UN2 User Manual
...
U-SERIES
UHF Wireless Systems
User Manual
Version 2.0
UHF Wireless Systems User Manual
Introduction
Thank you for choosing the Chord UHF-series wireless system. This professional wireless set provides a high
quality microphone with UHF radio system for freedom of movement without loss of audio quality. Please read
this manual before using this equipment in order to avoid damage through incorrect operation and to get the
best performance from your purchase.
Contents
Please take care when unpacking this product. Inspect for any damage and ensure you have the following
components…
UHF wireless receiver
Mains power adapter
6.3mm mono jack lead
2 x 1.5V AA battery (4 pieces for UH2, UN2 or UHN2)
Microphone / transmitter(s) – see table below
Model
Stock code
Microphone 1
Microphone 2
UH1
171.822 / 171.823
Handheld transmitter
-
UH2
171.825 / 171.826
Handheld transmitter
Handheld transmitter
UN1
171.838 / 171.839
Neckband mic. + bodypack
-
UN2
171.827 / 171.828
Neckband mic. + bodypack
Neckband mic. + bodypack
UHN2
171.820 / 171.821
Handheld transmitter
Neckband mic. + bodypack
UL1
171.846 / 171.847
Lavalier mic. + bodypack
-
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by
qualified personnel before further use.
Avoid impact or heavy vibration to any components, dropping the microphone can cause capsule failure.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.
Safety
Ensure that the correct adaptor is used, ensuring that the mains voltage is as stated on the adapter.
Avoid ingress of water or particles into the transmitter(s) or receiver
Use alkaline or NiMH batteries in the transmitter(s) and remove if unused for long periods.
Observe the correct polarity when replacing batteries
Placement
Keep all components out of direct sunlight and away from heat sources.
Do not place heavy objects on top of the receiver or transmitter(s)
If rack-mounting, secure the receiver to a 1U rack tray and do not place heavy items above the receiver.
Keep the transmitter(s) and receiver away from damp or dusty environments.
Cleaning
Use a soft cloth with a neutral detergent to clean the body of the microphone/transmitter and receiver.
Lightly damp sterile wipes may be used on the microphone grille for hygiene purposes
To avoid damage, do not use solvents to clean the components
Loading...