Chord UP2 User Manual

UP2

Portable UHF Wireless System

Item ref: 171.920UK, 171.921UK, 171.922UK, 171.923UK

User Manual

Version 1.0

UP2 User Manual

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

Introduction

Thank you for choosing this Chord UP2 portable UHF wireless system. The UP2 system is designed to offer a
flexible wireless platform for performance and communication applications. Please read this manual before
using this equipment to avoid damage through incorrect operation and to get the best performance from your
purchase.

Contents:

Please take care when unpacking this product. Inspect for any damage and ensure you have the following
components…

• UHF beltpack transmitter

• UHF beltpack receiver

• Neckband microphone

• Over-ear hook headphones

• Hot-shoe camera mount

• 3.5mm stereo jack lead

• 3.5mm 4-pole jack lead

• 4 x AA batteries

• ABS carry case

Warning

To prevent the risk of damage, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by
qualified personnel before further use.
Avoid impact or stressing of components and connectors or over-stretching of the cables.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.

Safety

• Avoid ingress of water or particles into the transmitter or receiver

• Use alkaline or NiMH batteries in the bodypack receiver and remove if unused for long periods.

• Observe the correct polarity when replacing batteries

Placement

• Ensure good line-of-sight contact between transmitter and receiver for best reception

• Keep all components out of direct sunlight and away from heat sources.

• Do not place heavy objects on top of the receiver or transmitter

• Keep the transmitter and receiver away from damp or dusty environments.

Cleaning

• Use a soft cloth with a neutral detergent to clean the body of the transmitter and/or receiver.

• To avoid damage, do not use solvents to clean the components

• Sterile wipes may be used on over-ear headphones – be sure to avoid ingress of fluids