USER MANUAL
BAR FRIDGE
Customer Service 1300 796 688
www.chiq.com.au
MODEL
CSR090DW
CSR089DB
PART NAMES AND LOCATIONS
No Description
1
Chill compartment door
2
Thermostat
3
Drip tray
4 Glass Shelf
5
Crisper cover
6
Crisper
7
Fridge door shelves
IN ACCESSORY BAG: USER MANUAL, WARRANTY CARD
As the manufacturer holds the authority to redesign or modify its products without notice:
Any modifications or upgrades of our products will result in this refrigerator varying
slightly from this manual but the functionality will remain the same to that as set out
within this manual.
1
IMPORTANT SAFETY INSTRUCTIONS
Follow these basic precautions to reduce the risk of fire,
WARNING
electrical shock hazards or injury when operating the
refrigerator:
• This product has been designed for using in a normal domestic environment. It is
not intended for commercial use which will avoid warranty, such as supermarket,
food shop, pharmacy, commercial kitchen & etc.
• Persons with lack of experience and knowledge, reduced physical or mental capabilities,
need to be given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
• It is critical use this appliance safely. Read all instructions before operating the
refrigerator and do not attempt to repair or modify this unit in any way as it can cause
harm or void the warranty.
• Please ensure all persons using this appliance are also informed and comply with the
details set out within this manual and the product Terms and Conditions.
• When unpacking the appliance for the first time, keep all cardboard and plastic
packaging out of reach from children.
• Report any notable defects with the appliance to Chiq or retailer as soon as it is noted.
Failure to do so can result in a non-warranty claim. Keep all packaging materials in a
safe location until the unit has been installed properly.
• If the supplied power cord of this unit is damaged, it must be replaced by qualify
service agent or similarly qualified persons in order to avoid any risk of injury. It is
recommended the power cord is situated in a safe location when operating or
transporting the appliance to prevent any damage that may cause electrical shock or
fire hazards.
• DANGER or WARNING:
Service of this unit
The installation or any service of the appliance is recommended by a qualified technician
or service company.
Ventilation Hazards
Never clean the refrigerator or refrigerator parts with flammable fluids, or store gasoline
or any other flammable vapors and liquids in the vicinity of this or any other
refrigerator as the gas and/or vapour can cause a fire hazard, explosion or inhalation.
Electrical Connection
Make certain, when installing or moving the unit that the power outlet has been
connected to, has been fitted by a qualified electrician and the ground wire has been
connected properly to meet the Australian Electrical Standards.
2
R600a WARNINGS
NOTE: This model uses R600a flammable refrigerant in its sealed system.
The following must be observed for your safety:
R600a Refrigerant Warning
• This appliance contains 0.02kg R600a refrigerant which is
environmentally friendly, but flammable. It does not damage the ozone
layer, nor does it increase the greenhouse effect.
• During transportation and installation, ensure that the tubing of the
refrigerant circuit is not damaged.
• Leaking refrigerant can ignite and may damage the eyes.
• In the event any damage does occur, avoid exposure to open fires and
any device which creates a spark. Disconnect the appliance from the
mains power.
• Thoroughly ventilate the room in which the appliance is located for
several minutes.
• Notify Customer Service for necessary action and advice.
• The room for installing the appliance must be at least 1 cubic metre per
8 grams of refrigerant. The refrigerant quantity contained in this
appliance is listed above in grams; it is also noted on the Rating Plate of
the appliance.
* Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
It is hazardous for anyone other than an Authorised Service Person to carry out
servicing or repairs to this appliance. In Queensland the authorized person must
hold a Gas Work Authorisation for hydrocarbon refrigerants, before carrying out
servicing or repairs which involve the removal of covers.
1. Keep ventilation openings, in the appliance enclosure or in the built-in structure,
clear of obstruction.
2. Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
3. Do not damage the refrigerant circuit.
4. Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
5. Do not store explosive substances such as aerosol cans with a flammable propellant
in the appliance.
Disposal
The environment and personal safety must be considered when disposing of this
appliance. Please ensure the appliance is taken to a recycle center for safe recycling. DO
NOT dispose of the appliance in land fill as the insulation and refrigerant gas contained
in these appliances are flammable.
3
Door reversal instruction
4
INSTALLATION INSTRUCTIONS
Before Using the Refrigerator
• Remove the exterior and interior packing.
• Before connecting the refrigerator to a power source, let the unit stand upright for
approximately 6 hours to mitigate the possibility of a malfunction in the cooling
system from improper handling during transportation.
• Clean the interior surface with warm water using a soft cloth.
Installing the Refrigerator
• This appliance is designed to be free standing only, and should not be recessed or
built-in.
• Allow at least 5cm of space between the back and sides of the refrigerator to
allow proper air ventilation. Insufficient space will result in cooling and working life
issue and voiding warranty.
• Place the refrigerator on a leveled/even floor surface that is strong enough to
support the weight of the refrigerator when it is fully loaded to prevent vibrations.
• Place the refrigerator on a concrete, tile floor or waterproof floor is
recommended. The fridge will produce defrost water or condensation moisture,
it might cause water damage in some extreme circumstances.
• The front feet can be adjusted to level the appliance properly. Adjust the two
front feet to keep the refrigerator leveled or elevated.
• Situate the refrigerator away from direct sunlight and sources of direct heat (stove,
heater, radiator, etc.). Direct sunlight may also affect the acrylic coating and heat
sources may cause an increase power consumption.
• This unit is not designed for outside installation.
• Avoid situating the refrigerator in moist OR pest infestation areas.
• Plug the refrigerator into dedicated, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorized service center.
• After plugging the appliance into a wall outlet, turn the unit on and allow the unit to
cool down for 4-6 hours before placing food in the refrigerator.
• Do not place heavy items on the top of this appliance.
ENERGY SAVING TIPS
• Allow hot foods to cool to room temperature before placing in the refrigerator.
Overloading the refrigerator forces the compressor to work harder. Foods that freeze
too slowly may lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
• Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
5
OPERATING INSTRUCTIONS
Temperature Control
The marks on the knob are the temperature grades, not
the exact number of the degrees of temperature.
"OFF" shows a forced STOP and "7" shows the coldest
setting. Turn the knob from "1" position to "7" position, the
temperature setting decreases continuously.
Set the knob to "4" position in normal use. But it can be
adjusted to the setting that best suits your needs.
Defrosting
The appliance isn’t frost free model and it need to manual defrost
regularly.
When the refrigerator works for a period of time, the top chill compartment will be
covered with a layer of thick ice. It may increase the power consumption and reduce
the cooling efficiency. Please do a manual defrost when ice is thicker than 10mm or
the door can’t be closed properly due to too much ice.
When defrosting, cut off the power, open the door and remove food to a shady
cooling place, wait for 2 or 3 hours, let the temperature rise naturally till ice gets soft
or melts. Then wipe away ice and water.
Notes: Please only use plastic scraper to remove ice if required.
Never use sharp metal tools and it might damage the gas pipe which
will avoid warranty.
The drip tray will collect water from chill compartment. Please
empty the tray regularly to void overflow.
6
Notes
Please note different sections of refrigerator compartment may be
warmer or cooler than others – typically the top back wall will be the
coolest, the door rack will be the warmest. To avoid frost bite, please
don’t put raw vegetables too close to the chill compartment.
Large quantities of food stored in the appliance or directly in front of the
air vent will hinder the cooling efficiency of the appliance as this can
affect the airflow.
Change the thermostat settings and allow 6 hours for temperature to
stabilize between adjustments.
Do not keep opening and closing the door which will increase the temperature
in the unit.
GENERAL CARE AND MAINTENANCE
Cleaning the Refrigerator
• Upon installation of your new appliance, it is recommended that it be cleaned
thoroughly and properly maintained thereafter.
• Turn off the refrigerator and then unplug the unit from the wall outlet.
• Remove all food content before washing the inside with a damp cloth soaked in
lukewarm water and dishwasher liquid. Don’t use any chemical detergent which
might damage the fridge.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently as
improper cleaning can cause the seal to dislodge and tear.
• Dry the interior and exterior with a soft cloth.
Vacation Time
• Turn off the refrigerator first and then unplug the unit from the power point.
• Remove all food.
• Clean the refrigerator.
• Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
• Use extreme caution in the case of children. The unit should not be accessible to
child’s play.
7
• Short vacations: Leave the refrigerator operating during vacations of less than three
weeks.
• Long vacations: If the appliance will not be used for several months, remove all food
and unplug the power cord. Clean and dry the interior thoroughly. To prevent odour
and mold growth, leave the door open slightly: blocking it open if necessary.
Repositioning and Relocating the Refrigerator
• Unplug the power cord from the wall outlet.
• Remove all the food and drinks.
• Securely tape down all loose items inside your refrigerator.
• Tape the doors to be closed securely.
• It is recommended that the refrigerator stays in the upright position during
transportation. But if it is laid down for transport purpose, please lift it up
immediately after the job is done. Please wait for at least 24 hours before putting the
power.
TROUBLESHOOTING GUIDE
8
Problem
There is no light in freezer compartment, only fridge
Bubbling or gurgling sound,
like water boiling.
Refrigerant (used to cool refrigerator) is circulating
Solution
The fridge has no power
The light is not working.
Compressor runs all the
time
Power cord isn’t plugged in properly.
The circuit breaker tripped or a blown fuse.
Try a different power point.
compartment has light.
Make sure the power is connected to the unit.
The room temperature is hotter than normal.
A large amount of food has been added to the
refrigerator.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The refrigerator does not have the correct clearances.
The refrigerator has recently been disconnected for a
period of time. 6+ hours are required for the refrigerator
to cool down completely pending on operating
conditions.
Temperature inside the
refrigerator is too warm.
Temperature inside the
refrigerator is too cold.
Temperature of external
refrigerator side walls are
warm.
Temperature control is set incorrectly. Turn the control
to a cooler setting and allow several hours for the
temperature to stabilize.
Door is kept open too long or is opened too frequently.
Warm air enters the refrigerator every time the door is
opened). Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
Temperature control is set too cold. Turn the control to a
warmer setting and allow several hours for the
temperature to stabilize.
The exterior refrigerator walls can be as much as 15-20
degrees warmer than room temperature.
This is normal while the compressor works to transfer
heat from inside the refrigerator cabinet to the condenser
behind the refrigerator side walls.
Popping or cracking sound
when compressor comes on.
Metal parts undergo expansion and contraction, as in
hot water pipes. This is normal. Sound will level off or
disappear as refrigerator continues to run.
9
throughout the system. This is normal operation.
Leaking water on the
bottom of the fridge
compartment
Vibrations.
Moisture forms on inside
refrigerator walls.
The drain hole might be blocked by food particle, please
clean hole and unblock it with a flexible metal wire.
Check the refrigerator is on a level/even surface.
Refrigerator rocks on the floor when it is moved slightly.
Be sure floor can adequately support refrigerator.
Level the refrigerator by putting wood or metal shims
under part of the refrigerator.
The refrigerator is touching the wall. Re-level the
refrigerator and move it from the wall. See “Installation
Instructions”.
Weather is hot and humid, which increases internal rate
of frost build-up. This is normal.
Door is slightly open.
Door is kept open too long, or is opened too frequently.
Open the door less often.
The door is not sealed properly.
Moisture forms on outside
of refrigerator.
The doors will not close
properly.
Door is slightly open, causing cold air from inside the
refrigerator to meet warm moist air from the outside.
The refrigerator is not on a level surface.
The gasket/s may be dirty or not properly maintained.
Clean the seals and make sure they are dry before
closing the door/s.
The storage basket and/or shelves are out of position.
For any enquiries, please call the CHiQ Cusotmer care on: 1300 796 688
Customer Service
1300 796 688
www.chiq.com.au
c
Changhong Electric (Australia) P/L all rights reserved.
Loading...