Chip Quik SMD Instruction Manual

Instructions

ge

4

l

SMD Removal Method

using a standard solder iron

Instructions

Apply Chip Quik flux to all leads of SMD with syringe or flux

1.

applicator.

Melt Chip Quik low temperature alloy uniformly on all pins of SMD.

2.

Maintain alloy in molten state long enough for complete reflow.

Page 1 of 1Instructions

Lift chip from board with dental pick or Vacpick.

3.

Thoroughly clean site with swab dipped in flux while applying heat.

4.

Clean thoroughly with alcohol pad.

SMD REMOVAL
[with solder iron or warm air bath]

z Apply flux to all leads with syringe.
z Melt CHIP QUIK uniformly on all pins.
z Maintain alloy in molten state long enough to release chip.
z Lift chip from board with dental pick or Vacpick.

CLEAN UP

z While molten, use cotton swab and flux to move excess to an unused section of board.
z While applying heat, polish each pad with a swab and flux until thoroughly clean.
z At room temperature clean residue with alcohol pad.
z You are now ready to install the new chip.

material, removes 1250 to 1500 SMD pins.

PATENT #5.326.016

Home Pa

http://www.chipquik.com/instructions.htm

9/30/201