CHINA ELECTRONICS Q6 User Manual
Bluetooth speaker
Q6
User Manual
China Electronics Shenzhen Company
Content
1.Welcome …………………………………..…… 3
2.General Information ..…………………………… 3
3.Warnings and Precautions ……………………….3
4.Getting to Know Your SP2 ..….………..…..…….5
5.Features and Specifications ……………………….6
6.Included in the box .…………………….…………6
7.Charging the Speaker ……………………………6
8.Pairing Bluetooth® Device ………………………7
9.Basic Instructions ..….............................................7
10.LED Status Indicator ……………………………7
SWITCH OFF WHEN ON AN AIRCRAFT
Wireless devices can cause interference in an aircraft. Using a Device in
flight is illegal and risky. Please make sure your Device is turned off
while in flight.
OBSERVE ALL SPECIAL REGULATIONS
Follow any special regulations that are enforced in locations such as
hospitals. Always switch off your Device whenever Device use is
f
orbidden or when it may cause interference or danger.
Use caution when using your Device near medical devices, such as
pacemakers, hearing aids and other electronic medical devices, as it may
cause interference and not allow these devices to perform properly.
INTERFERENCE
An antenna is built-in to the Device and must be not
An antenna is built-in to the Device and must be not
co-located or operated in conjunction with any other antenna or
co-located or operated in conjunction with any other antenna or
transmitter.
trans
mitter.
QUALIFIED SERVICE
QUALIFIED SERVICE
O
O
nly qualified personnel may install or repair t he Device. Installing or
nly qualified personnel may install or repair t he Device. Installing or
Getting to Know Your Logic
Q6
Side View
An led View
1. Power On/Off
2. 3.5mm audio input
(line-in)
3. LED (Red/Blue)
4. Micro USB connector
Features and Specifications
• Output Power: 2W
• Frequency Response: 150Hz-16kHz
• RMS: (THD=10%)
• Driver: 45mm
• Power Supply: USB, DC 5V 00mA
• Distortion: <1%
• S/N: >60dB
®
• Bluetooth
wireless connectivity
• Battery Capacity: 00mAh
• Battery Play Time: 1-1.5 hours
• Battery Charging Time: 1-1.5 hours
• Product Size: 83x33x68mm
• Product Weight: 150g
Included in the Box
1. Speaker
2. User M
anual
3. USB to Micro-USB Cable
4. 3.5mm Audio Cable
Charging the Speaker
Before using the speaker for t he first time you must charge it for at least 24
hours. Use a computer USB port or an AC power adapte r with a USB
connector. When the battery is low, approximate ly 1.5-2 hours of
Pairing Bluetooth® Device
1. Place speaker within 30ft of the Bluetooth®-enabled device.
2. Slide the ON/OFF butto
then flashes quickly to indicate Bluetooth
4
4
n to ON. The blue LED flashes 3 times slowly,
®
pairing mode.
Welcome
Thank you for purchasing this innovative Logic product. We invite you to
read the instructions contained in this user manual so you can configure and
utilize all the functions your new Device has to offer. For additional
information visit us at: logicmobility.com.
General Information
The specifications in this manual are subject to change without prior notice.
Logic, Inc. reserves the final right to interpret the performance of this mobile
device. While the utmost care was taken and the latest information compiled
in the production of this manual neither Logic, nor any other affiliated
company, assumes responsibility for any mistakes or errors that may be
contained in this document.
Screen captures, images, diagrams or representations presented in this manual
are for reference purposes. The actual screens or functions may vary due to
different software versions or other factors. Please refer to your Device for
the correct details.
Logic and the Logic logo are registered trademarks of Logic, Inc. Other
trademarks are the property of their respective owners.
Warnings and Precautions
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
3. Follow the instructions of your device to search for t he speaker.
4. The speaker is called " ." If a PIN is required, enter "0000."
5. The blue LED flashes slowly when pairing is co mplete.
Basic Instructions
To turn the speaker on, slide the ON/OFF button to ON.
The speaker beeps and the blu
The blue LED stays on when playing music.
To turn the speaker off, slide the ON/OFF button to O FF.
LED Indicator Status
Charging: Red LED on
Fully Charged: Red LED off
Pairing Mode: Blue LED flashes quickly
Connected: Blue LED on
Playing: Blue LED flashes slowly
Q6
e LED flashes slowly.
Loading...