CHINA ELECTRONICS F300 User Manual
B
LUETOOTH SPEAKER
Instruction Manual
7198-61
Functions:
1.
Mic/Speaker
2.
Vol+/Next Track
3.
Play/Pause/Phone
4.
Vol-/Previous Track
5.
Power Button
What’s included:
1 x
Speaker (7198-61)
1 x
Micro-USB Charging Cable
1 x
3.5mm Aux Cable
1 x
Instruction Manual
•
Playing time: up to 4 hrs at max volume
•
Charging time: up to 3.5 hrs
•
Pairing Name: “Wells Outdoor”
6.
AUX Port
7.
Reset Button
8.
Micro USB Port
Instructions:
(Be sure to fully charge the speaker before
Charging the Speaker
1.
Connect the provided charging cable to a
•
power source and to the micro USB port on
the speaker (8).
The LED indicator light will glow red when
*
charging and turn off when fully charged.
Bluetooth® Setup:
2.
Long press “Power Button”(5) to turn on and
•
start pairing.
•
look for “Wells Outdoor” on your Bluetooth
device and select it to pair with device.
Once pairing is successful the blue light will
•
Long press again to turn OFF the device.
•
Playing Music:
3.
Short press (3) “Play/Pause/Phone” key
•
to pause music. A second short press will
resume playing music again.
Long press (4) “Previous track/Vol-”, the
•
speaker will play the previous track.
Short press to reduce speaker volume.
•
Long press (2) “Next track/Vol+”, the speaker
•
will play the next track.
Short press to increase speaker volume.
•
AUX Function:
4.
Find the speakers AUX-IN port, plug in
•
supplied 3.5mm AUX cable into the port and
connect to the mobile device.
Call Function:
5.
Short press “Play/Pause/Phone” (3) to
•
answer a incoming call, press again to
end call.
Press and hold to reject the call.
•
Press “Power Button” twice to redial last
•
called number from the speaker.
SAFETY PRECAUTIONS:
WARNING-When using this product, basic
•
precautions should always be followed:
Read all the instructions before use.
1.
Never store or use this product in
2.
temperatures below 32°F(0°C) or above
115°F(45°C).
The unit’s full performance is achieved
3.
only after 2 or 3 completed charge and
discharge cycles.
4.
To reduce the risk of injury, close
supervision is necessary when the product
is used near children.
5.
Do not expose the device to moisture.
6.
Do not use the device in excess of its
output rating. Overload outputs above
Do not use the device if damaged or
7.
8.
explosion or risk of injury.
Do not disassemble the device. For
9.
professional. Incorrect reassembly may
10.
or temperatures above 104°F may cause
explosion.
11.
use only identical replacement parts to
ensure product safety
FCC Statement:
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment general uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions (1) this device may not cause
harmful interference, and (2)this device must
accept any interference received, including
interference that may cause undesired
operation.
RF Exposure Information
The device has been evaluated to meet general
RF exposure requirement. The device can be used
in portable exposure condition without restriction.
M
ADE IN CHINA
Loading...