Childcare Uno White 044289-003 Quick Start Manual

Uno

High Chair “White”

Model # 044289-003

IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY

SAFETY PRECAUTIONS

Read all instructions before assembly and use of the high chair. Keep instructions for future use.

WARNING

FOLLOW THE MANUFACTURERS INSTRUCTIONS
DO NOT LEAVE CHILDREN UNATTENDED.
THE HARNESS MUST ALWAYS BE USED AND CORRECTLY FITTED - MOST INJURIES FROM HIGHCHAIRS ARE

CAUSED BY FALLS.
POSITION THE HIGH CHAIR AWAY FROM SOLID STRUCTURES AND BENCHES TO AVOID INJURIES CAUSED BY

FALLS AND BY ACCESS TO DANGEROUS ITEMS.
DO NOT USE THE HIGH CHAIR UNLESS ALL COMPONENTS ARE CORRECTLY FITTED AND ADJUSTED.
BE AWARE OF THE RISK OF OPEN FIRE AND OTHER SOURCES OF STRONG HEAT, SUCH AS ELECTRIC BAR FIRES,

GAS FIRES ETC, IN THE VICINITY OF THE HIGH CHAIR.
DO NOT USE THIS HIGH CHAIR UNTIL THE CHILD CAN SIT UP UNAIDED.

Check that all safety locks are engaged before placing a child in the high chair.
Always keep child in view while in high chair.
Not recommended for a child under 6mths old.
The tray is not designed to hold the child in the high chair.
Use safety harness at all times.
Always secure your child in the restraint. Ensure that your child wears a correctly tted and adjusted harness at all times.
Only use high chair on a at, even and horizontal oor.
Do not elevate the high chair on any structure or table.
Do not allow children to stand on the seat or climb into or out of the high chair.
When adjusting the high chair, make sure that parts of your child’s body are clear of any moving parts.
Do not carry the high chair with a child in it.
To reduce the risk of injury, position the high chair away from furniture, walls, hot surfaces and liquids, window covering cords, and electrical

cords. Position the high chair away from furniture when the high chair is not being used at a table with the tray removed.
The high chair should only be used in an upright position once the child is capable of reliably and consistently sitting upright.
Periodically check that all parts of the high chair are in good working order.
Do not use the high chair if it is damaged or broken, contact CNP Brands for repair advice.
The weight of the child using this high chair should not exceed 15kgs.
Avoid crushing the high chair when storing or loading into a car.
Promptly replace worn out or broken parts.

Check what you have received...

You have received 1 box. Please check the contents of the box against the list below. If anything is missing, please contact Customer
Service. In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact Wainhouse Distribution on 0800 567 5000.

Supplied loose in box:

Seat with Harness x1 Tray x1 Top Legs x4 Lower Legs x4

Uno

High Chair “White”

Model # 044289-003

IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY

ASSEMBLY OPERATING INSTRUCTIONS

To assemble legs onto seat...

1 1

Slide the front top legs with

1a.

grooves into the front holes of the
seat, ensuring the grooves align
correctly with internal tab. Depress
spring pin and push leg into seat,
ensuring pin pops into retaining
hole on seat. Repeat for rear legs.

2 2

Push the four lower leg bars onto

2a. 2a.

the four top legs by depressing
springpin and pushing each top
leg in. Ensure spring pin pops out
of retaining hole.

Attaching and removing tray...

Hook in tray pegs into the

1a.

positioning slots as shown in
image. Push tray down until it
rmly clips onto seat. Make sure
tray is secured by grabbing and
lifting tray.

Grab the tray on the left or right
in position shown. Whilst holding
chair down, rmly lift and unhook
tray and remove.

Harness restraints...

Removing harness from seat

Low chair mode...

for cleaning...

To secure child in harness,

1a.

push buckle (a) and (b) into

shoulder

straps

buckle

d d

buckle
prongs

housing

c

buckle

ba

prongs

the buckle housing (c) until
the buckle prongs snap into
position.

1b.

Carefully adjust the harness
by pulling the slider (d) until

sliderslider

the desired t is achieved in
the lap, shoulder and crotch
strap.

1c.

To release the buckle,
squeeze the top and bottom
prongs until it disengages.

CAUTION: The harness
must be used at all
times and be correctly
adjusted - most injuries
from highchairs are
caused by falls.

1

Remove D ring from harness strap

1a.

by sliding webbing through the
slot in the D ring as shown.

1b.

Push strap end through slot in seat
and remove harness as shown.

CAUTION: ALWAYS re-t harness
after cleaning and

before re-use.

1

Remove the upper legs and insert

1a.

4 x lower legs directly into the seat
base.

HOW TO CARE FOR YOUR CHILDCARE HIGH CHAIR

Cleaning

To ensure the long-lasting use of your highchair wipe down with a damp cloth and use a mild soap solution if
necessary. Do not use abrasive cleaners. Always store product in a clean dry place.

Maintenance

Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if required. To
maintain the safety of your highchair, seek prompt repairs for bent, torn, worn or broken parts. Use only those
parts and accessories approved by CNP Brands.

If you have any difculties in assembling the high chair, please contact our Service Department. In Australia, contact CNP

Brands on 1300 667 137, in New Zealand contact Wainhouse Distribution on 0800 567 5000.