Chieftec SNT-2131 SATA User Manual

SNT-2131 SATA Back Plane

User’s Manual

Features of product ---

 Aluminum Frame, Aluminum cover
 Interface: Support SATA-I, SATA-II
 High performance transfer rate up to 150MB/s, 300MB/s
 Plug & play, hot swappable
 Point to point, free from master/slave setting
 SATA 15Pin & Molex 4Pin Power connectors
 LED for PSU , HDD access, Fan sensor & Buzzer
 Power Control Switch
 Reset Switch for buzzer alarm
 8cm FAN X1
 Magic Handle—Auto In/Out
 Color for choice: black
 Dimension: 202(L) X 146(W) X 86(H) mm
 Patent products with advanced structure design
 Precisely connection on connector (see picture A)

---Caddy Drive Drawer Install--­Use TM#6*4 long screws to mount the drive in the drawer. (see picture C)

---Front Panel--- (see picture D)

D.1--- Reset Switch for buzzer alarm and

Overheating LED

When overheatin

g

occurs the buzzer

alarms (default setting: 60°C and the

temperature LED turns red meanwhile

buzzer is alarming and LED is blinkin

g

).

press the Reset Switch to stop the alarm,

and LED goes off.

D.2--- D.4 (HD1〜HD3, Power SW and LED:

Power on, LED indicates Green. Oran

g

e

color blinking for HDD access)

D.5--- Fan sensor LED: LED is indicatin

g

Green when it is working. When the fan

fails, LED turns Red.

D.6--- Safety Lock

The safety lock safe

g

uards the hard disk

in the correct position and prevents it

bouncin

g

out while HDD is working. (see

Picture E)

Picture E

POWER1: 4pin Power connector

POWER2: 15pin Serial ATA Power

connector

HD1—HD3: 7pin Serial ATA Signal

con

in

ower

r.

can mix using 4pin and 15pin

r

ch for buzzer alarm and

ture detection (red)

ture detection (green)

J4: FAN RPM HIGH & LOW Optional

nector

If your power is not from SATA 15p

connector, please use the 4pin p

connector. The 4pin power will

automatically be converted to SATA powe

(Note: you

powers）

lJP1: Temperature setting jumpe

lJP3: Extension function jumper

FLEDR: Fan failure detection (red)

FLED+: Fan failure detection (+)

FLEDG: Fan failure detection (green)

RESET: Reset Swit

Overheating LED

TLEDR: Tempera

5V+: 5V Power

TLEDG：Tempera

GND：Grounded

---Rear View--- (see picture F)

Picture F