Chief Manufacturing FSA-1017 User Manual

INSTALLATION INSTRUCTIONS

Pole Clamp Accessory
Model: FSA-1017

The FSA-1017 Pole Clamp Accessory is used to provide
a means for attaching a desktop or wall mount to a
1 1/2" to 2" pole.

BEFORE YOU BEGIN

CAUTION!

To prevent damage to the Kit, which could affect or void the Factory warranty, and to the equipment that will be
attached to it, thoroughly study all instructions and illustrations before you begin the installation.

• If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480.

CHIEF MANUFACTURING INC.

1-800-582-6480 952-894-6280 FAX [phone]
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA

©2005 Chief Manufacturing

8807-000042

www.chiefmfg.com

12/05

Model: FSA-1017 Installation Instructions

INTRODUCTION
TOOLS REQUIRED FOR INSTALLATION

• 5/32" Hex Key (provided)

BHCS

INSPECT MOUNT BEFORE ASSEMBLY

Carefully inspect components for shipping damage . If
damage is apparent, call your carrier claims agent and do
not continue with installation until the carrier has
reviewed the damage.(see Figure 1)

Flat Washer

Nylon Washer

Tabl e 1: Parts

Ref. Description QTY

10 CLAMP, Front, Pole Mount 1
20 CLAMP, Rear, Pole Mount 1
30 SCREW, Button Head Cap, 3
40 KEY, Hex, 5/32" (not shown) 1

20

10

30

Figure 1: PARTS

Swing Arm

Existing Mount Base

Nylock Nut

Flat Washer

Pivot Pin

Large Nylon Washer

Figure 2: Remove Mount from Existing Base

POLE CLAMP INSTALLATION

1. Insert Nylock nut (previously set aside) crown down
into front half of pole clamp. (see Figure 3)

EXISTING MOUNT PREPARATION

Prior to installing the FSA-Pole clamp, the existing mount
has to be modified.

To prepare the existing mount:

1. Remove display, if present, from existing mount
following the instructions supplied with mount.

2. Loosen button head cap screw securing swing arm to
base on existing mount using a 5/32" hex key (40).
(see Figure 2)

3. Uninstall button head cap screw, one nylon washer,
and two flat washers from swing arm and set aside for
reuse. (see Figure 2)

4. Lift swing arm up and of f of pivot pin and set aside for
reuse. (see Figure 2)

5. Remove large nylon washer , pivot pin, and Nylock nut
from existing mount base and set aside for reuse.
(see Figure 2)

2

(10)

Nylock Nut

Figure 3: Insert Nylock Nut