Chief Manufacturing FDP User Manual

t

ove latc

INSTALLATION INSTRUCTIONS

FDP SERIES

SMALL FLAT PANEL DISPLAY

DUAL SCREEN POLE MOUNT

Exclusive Q2™ Mounting System

Prior to assembly, unpack carton completely and verify contents.

If you are missing any of the following components, please contact Customer Service at 1-800/582-6480.

(2) FDP Pole-Mounting Bracket Half (2) ¼” Flat Washer
(2) ¼-20 X 4.25” Hex Bolt (8) 10-24 X 1.00 Thread Forming Screw
(8) ½” X ½” Nylon Spacer

BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY

The FSP will fit on any 1/1/2” to 2” O.D. pipe including 1 ½”NPT.

Flat Panel Displays are Extremely Fragile.

CAUTION!

Interface Bracket Installation:

1. See installation procedures accompanying your mounting bracket.

Optional Latching Flag Placement:

1. Remove Phillips head screw, Nylock nut and latching flag (see Figure 2).

2. Reposition latching flag and secure using Phillips head screw, Nylock nut.

Remove screw
and nu

If Monitor Uses a Screw Size Other Than M4 X 10mm (M4 X 20mm),
DO NOT USE M4 Screws Provided. Monitor Damage Could Occur.

M

Figure 1

h

8803-000033 01/26/04

CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [e-mail]

Figure 2

p

Pole-Mounting Bracket Assembly and Installation:

1. Assemble two pole-mounting bracket halves as shown in Figure 3 and secure using two ¼-20 X 4.25”
hex bolts and two ¼” flat washers.

2. For vertical pole mounting, install the pole-mounting bracket on 1 ½” to 2” OD pipe/pole and secure
using 7/16” hex drives (see Figure 4).

3. For horizontal pole mounting; remove eight tilt adjustment screws, reposition the tilt bracket as
shown in Figure 5, and insert nylon spacers. Secure using 10-24 x 1.00 screws provided.

Unlocked

¼-20 X 4.25” hex bolt

and ¼” washer
Tighten to
secure to

ole

Figure 3

Figure 4

Mounting Display with Interface Bracket to Pole-Mounting Bracket:

1. Make sure both latching flags on pole-mounting bracket are in the unlocked position (see Figure 4).

2. Place your small flat panel displays; with interface brackets attached, onto the pole-mounting bracket,
making sure they are securely seated.

3. Engage pole-mounting bracket latching flags, locking small flat panel displays in place (see Figure 6).

4. Adjust tilt by loosening (slightly) tilt adjustment screws (see Figure 7) on each side of pole-mounting
bracket, adjust to desired angle, and tighten tilt adjustment screws.

Locked

10-24 x 1.00 screw

.500 O.D. x .500
long nylon spacer

Figure 5

Tilt
Adjustment
Screws

Figure 6

8803-000033 01/26/04

CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: [phone], Email: [e-mail]

Figure 7