
INSTALLATION INSTRUCTIONS
SLB-317 and SLM-317 Interface Brackets
SLB-317 and SLM-317 Interface Brackets are desi gned for use with Chief® Series Projector Mounts. See the specific installation instructions
provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any list ed parts are missing, immediately contact a Chief Customer Service representati ve.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
(1) Interface Bracket (6) Screw, Phillips Pan H ead, Ma chin e, M6 x 12mm
(6) 10-24 Thumb Nuts ** (6) Washer, M6
(1) All-Points Security Kit (1) 5/32" Hex Key
Towards front
of projector
SLB-317
**Only used when installing SLB interface brackets.
Towards front
of projector
SLM-317
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB interface bracket. If an SLM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the
bottom of the projec tor and ensuring that triangl e in bracket points towards front of projector.
4. Position M6 x 12mm mounting screws with M6 flat washers into the threaded inserts and bracket side tabs. Tighten all fasteners at this
time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mount i ng Interfa ce br acke t to pro je ctor by u sing th e part s and in sta llatio n in structi ons i n the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
Milestone AV Technologies, and its affiliated co rpo rat ions a nd s ubs id iaries (collectively, "Milestone"), intend to mak e th is ma nual ac curate and complete. However, Milestone mak es
no claim that the information contained h erein co vers all details, conditions or variations, nor does it provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
6436 City West Par kway, Eden Prai rie, MN 55344
©2013 Milestone AV Technologies,
a Duchossois Group Company
8800-0 02 50 0 R ev 01
12/13