Chief SLM195 Installation Guide
INSTALLATION INSTRUCTIONS
SLB-195
SLM-195
SLB-195 and SLM-195 Interface Brackets
SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
(1) Interface Bracket (4) Screw, Phillips Pan Head, M4 x 12mm
(6) 10-24 Thumb Nuts ** (1) Screw, Phillips Pan Head, M4 x 25mm
(1) All-Points Security Kit (5) Washer, Flat , M4
(1) Spacer, Nylon, .500" x .257 x .625"
Front of Projector
**Only used when installing SLB Interface brackets.
Front of Projector
Installation:
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.
1. Screw six thumb screws onto six 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the i nte rface bracke t ont o t he bot t om of the pr oj ector l in ing up the four out sid e h ole s in t he brac ket wi t h the four threaded inser ts in
the bottom of the projector.
4. Slide the nylon spacer between bracket and the projector, lining it up with the front mounting hole in the bracket.
5. Place the four M4 X 12mm mounting screws and M4 washers in the four out side holes and the M4 X 25mm mounting screw and M4
washer in the front mounting hole and through the nylon spacer by hand, secure all five fasteners at this time.
NOTE: Securi ty scre ws can be s ubsti tuted whe n mount ing Inter fac e bracket to projec tor by us ing the p arts and ins tall ation instruct io ns i n th e
All-Points Securit y Kit.
CSAV, Inc., and its affiliated c orp orations and subsidiaries (collectively, "CSAV"), intend to make t his ma nual accurate and complete. However, CSAV makes no claim that the infor-
mation contained herein c overs al l detai ls, condi tions or va riatio ns, nor do es it pr ovide f or every p ossible cont inge ncy in conne ction wi th t he install ation or u se of th is product. The
information contained in this document is subject to change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the
information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
© 2007 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000264
8/16/07
Loading...