CHIEF SLB-9000 Instruction Manual

I N S T R U C T I O N M A N U A L

LB-9000

eiling Bracket

The Chief SLB Projector Mount provides a unique, simplified
method of mounting your LCD/DLP projector. This low pro­file design offers three easy mounting methods (1”NPT, flush
or threaded rod); roll, pitch and yaw adjustment; and cable
management system; that allow quick projector disconnect
without loss of registration.

The mount is constructed of heavy gauge steel and designed to
ensure proper projector ventilation. Fast and precise image reg­istration is achieved through the easy roll, pitch and yaw
adjustments built into the Chief SLB Projector Mount.

Please read and follow these installation instructions carefully
before installing products.

BEFORE YOU BEGIN

• CAUTION: To prevent damage to the SLB-9000, which could affect or void the Factory warranty, thoroughly study all

instructions and illustrations before you begin to install the SLB-900. Pay particular attention to the “Important Pre­cautions” on Page 1.

• The maximum weight to be installed on the SLB-9000 is 50 pounds (22.68 Kg).

• If you have any questions about this assembly, contact Chief Manufacturing at 1-800-582-6480.

PART NO. 8802-000118 (Rev. A)

2003Chief Manufacturing

www.chiefmfg.com

Printed in USA 12-03

LOGO

CHIEF MANUFACTURING INC.

1-800-582-6480 952-894-6280 FAX [phone]
12800 HIGHWAY 13 SOUTH, SUITE 500
SAVAGE, MINNESOTA 55378 USA

Instruction Manual SLB-9000

IMPORTANT WARNINGS AND CAUTIONS!

WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the cor-

responding instructions.

• WARNING: Improper installation can result in serious personal injury! Make sure that the structural members can

support a redundant weight factor five times
support this weight, reinforce the structure before installing the SLB-9000.

• WARNING: You must use proper attaching hardware and installation procedures. Failure to use proper attaching

hardware and installation procedures may result in equipment damage or serious personal injury.

• WARNING: Be aware of the potential for personal injury or damage to the unit if it is not adequately mounted.

• WARNING: The installer is responsible for verifying that the mounting surface structural members to which the

mount is anchored will safely support the combined load of all attached components or other equip­ment.

• CAUTION: Inspect the unit for shipping damage.

the total weight of the equipment. If the structure can not

• CAUTION: When attaching the mount, be careful not to overtighten mounting screws.

• CAUTION: Changes or modifications not approved by Chief Manufacturing could void user’s warranty.

TOOLS REQUIRED FOR INSTALLATION

• Phillips screwdrivers, No. 1 and No. 2

NOTE: Other tools may be required depending on the

method of installation.

1

Instruction Manual SLB-9000

CONTENTS

INSPECT THE BRACKET AND
ATTACHING HARDWARE BEFORE

INSTALLING ...................................................... 3

SELECT PROJECTOR MODEL AND

DETERMINE PARTS .......................................... 3

BRACKET INSTALLATION PROCEDURES .. 5

Group A Installation Procedures: ..................... 5

Group B Installation Procedures: ..................... 5

Group C Installation Procedures: ..................... 6

Group D Installation Procedures: ..................... 6

Group E Installation Procedures: ..................... 7

PARTS .................................................................. 8

2