Page 1
INSTALLATION INSTRUCTIONS
SAMS-2132
PLASMA DISPLAY MOUNT
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
Figure 1
(1) Bracket, Plasma Mounting (1) Allen Key, 5mm
(4) Screws, M8 x 35mm Button Head Cap (4) Mounting Buttons, Nylon stepped
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
CAUTION!
WARNING!
PLASMA DISPLAYS ARE EXTREMELY FRAGILE.
ALL COMPONENTS MUST BE SECURELY FASTENED TO A
STRUCTURAL MEMBER CAPABLE OF SUPPORTING 4
TIMES THE COMBINED WEIGHT OF ALL COMPONENTS
PLUS THE EQUIPMENT BEING MOUNTED. IF IT CANNOT
SUPPORT THIS WEIGHT, THE STRUCTURE MUST BE
REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON THE
MOUNT IS 175 POUNDS (79.38 KG).
1. Attach mounting buttons to back of display using the M8 x 35mm button head cap screws provided (see
Figure 2 and Figure 3
Figure 2
CHIEF MANUFACTURING INC. 8804-000189 REV. A
1-800-582-6480 952-894-6280 FAX 952-894-6918 2004 Chief Manufacturing
8401 EAGLE CREEK PKWY, STE. 700 www.chiefmfg.com
SAVAGE, MINNESOTA 55378 USA 10/04
).
Figure 3
Page 2
2. Securely anchor plasma mount to the wall using wall studs or supporting framework (see Figure 4). The small
center hole can be used to lightly hold the mount in place while marking drill hole locations.
Figure 4
3. Make sure the flag is lowered to the side before attempting to place the display on the mount (See
Figure 5).
Figure 5
Figure 6
4. With the aid of another person, lift the display up to the mount, align the mounting buttons on the display with the
teardrop slots in the mount, and set the display into place.
Figure 6)
5.
Set mount to desired tilt and tighten nuts, a 1/2” wrench required (See Figure 7).
Position (raise) the flag to secure the display (See
Align Mounting
Buttons with
Teardrop Slots
Anchor to wall
using four slots
Figure 7
Loading...