CHIEF PAC717 User Manual

Page 1
INSTALLATION INSTRUCTIONS
Instrucciones de instalación Installationsanleitung Instruções de Instalação
Istruzioni di installazione Installatie-instructies Instructions d´installation
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
PAC717
Page 2
PAC717 Installation Instructions
7.06 DISTANCE
FROM CART/STAND
179.3
70°
12.39 INSIDE
314.7
2.90
73.7
12.50
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief® is a registered trademark of Milestone AV T echnologies. All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING:
serious injury or death if you do not follow the instructions.
A WARNING alerts you to the possibility of
CAUTION:
damage or destruction of equipment if you do not follow the corresponding instructions.
WARNING:
follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided.
WARNING:
for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
WARNING:
serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all literature and accessories mounted on the PAC717 does not exceed 25 lbs (11.34 kg).
A CAUTION alerts you to the possibility of
Failure to read, thoroughly understand, and
Failure to provide adequate structural strength
Exceeding the weight capacity can result in
DIMENSIONS
2
Page 3
Installation Instructions PAC717
Tighten Fastener
Apretar elemento de fijación Befestigungsteil festziehen Apertar fixador Serrare il fissaggio Bevestiging vastdraaien Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación Befestigungsteil lösen Desapertar fixador Allentare il fissaggio Bevestiging losdraaien Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips Kreuzschlitzschraubendreher Chave de fendas Phillips Cacciavite a stella Kruiskopschroevendraaier Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca Gabelschlüssel Chave de bocas Chiave a punte aperte Steeksleutel Clé à fourche
By Hand
A mano Von Hand Com a mão A mano Met de hand À la main
Hex-Head Wrench
Llave de cabeza hexagonal Sechskantschlüssel Chave de cabeça sextavada Chiave esagonale Zeskantsleutel Clé à tête hexagonale
Pencil Mark
Marcar con lápiz Stiftmarkierung Marcar com lápis Segno a matita Potloodmerkteken Marquage au crayon
Drill Hole
Perforar Bohrloch Fazer furo Praticare un foro Gat boren Percez un trou
Adjust
Ajustar Einstellen Ajustar Regolare Afstellen Ajuster
Remove
Quitar Entfernen Remover Rimuovere Verwijderen Retirez
Optional
Opcional Optional Opcional Opzionale Optie En option
Security Wrench
Llave de seguridad Sicherheitsschlüssel Chave de segurança Chiave di sicurezza Veiligheidssleutel Clé de sécurité
LEGEND
3
Page 4
PAC717 Installation Instructions
1/2" (12.7mm)
A(1)
B(1)
C(2)
D(1)
E(4)
3/8"
[Literature tray]
[Shelf column mount]
[5/16-18 knob]
[Shelf bracket]
TOOLS REQUIRED FOR INSTALLATION
PARTS
4
Page 5
Installation Instructions PAC717
2
(E) x 4
(A)
(B)
1
(B)
(D)
(C) x 2
3
(C) x 2
1
Knobs shown removed for viewing purposes only
(D)
Knobs shown removed for viewing purposes only
(D)
2
Assembly And Installation
Assemble Literature Tray
1. Place shelf column mount (B) over bolts on back of literature tray (A). (See Figure 1)
2. Install four 3/8" hex nuts (E) to bolts on back of literature tray (A) to secure shelf column mount (B) to tray. (See Figure 1)
Attach Literature Tray to Cart/Stand
1. Loosen back bracket (D) by turning both knobs counterclockwise. Do NOT remove knobs. (See Figure 3)
Figure 3
2. Slide bracket to the left until it disengages from the right stud. (See Figure 4)
Figure 1
3. Place shelf bracket (D) over bolts on flanges of shelf column mount (B). (See Figure 2)
4. Thread two 5/16-18" knobs (C) onto bolts until shelf bracket is secured to shelf column mount. (See Figure 2)
Figure 2
Figure 4
3. Let the bracket drop down and hang from the shelf’s left stud. (See Figure 5)
5
Page 6
PAC717 Installation Instructions
Knobs shown removed for viewing purposes only
(D)
3
Knobs shown removed for viewing purposes only
5
6
(C) x 2
2
(C) x 2
1
3
4
Figure 5
4. Position shelf column mount (B) around lower extrusion of cart/stand at desired mounting height. (See Figure 6)
5. Raise shelf bracket and hook over shelf’s right stud. (See Figure 6)
6. Turn both knobs clockwise to tighten the shelf in place. (See Figure 6)
Figure 7
3. Let the bracket drop down and hang from the shelf’s left stud. (See Figure 8)
4. Adjust literature tray to desired height. (See Figure 8)
Figure 6
Adjustments
Height Adjustment
1. Loosen back bracket (D) by turning both knobs counterclockwise. Do NOT remove knobs. (See Figure 7)
2. Slide bracket to the left until it disengages from the right stud. (See Figure 7)
6
Figure 8
5. Raise shelf bracket and hook over shelf’s right stud. (See Figure 9)
6. Turn both knobs clockwise to tighten the shelf in place. (See Figure 9)
Page 7
Installation Instructions PAC717
5
6
(C) x 2
Figure 9
7
Page 8
PAC717 Installation Instructions
Chief Manufacturing, a products division of Milestone AV Technologies
8807-002002 REV 01 ©2009 Milestone AV Technologies, a Duchossois Group Company
www.chiefmfg.com
05/09
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620 F +31 (0)40 2668615
Asia Pacific A Room 24F, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 92 26 F +86-755-8996 9217
Loading...