CHIEF NAGS1 User Manual

INSTALLATION INSTRUCTIONS

NAGS1

S1 Ganging Hardware

The NAGS1 ganging hardware is designed for use with Chief® S1 Raxxess racks. See the specific installation instructions provided with the
rack for additional installation information.

TOOLS REQUIRED / PARTS INCLUDED

A (4)
[Ganging hardware]

WARNING: FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN RESULT IN SERIOUS

PERSONAL INJURY, DAMAGE TO EQUIPMENT, OR VOIDING OF FACTORY WARRANTY! It is the installer’s responsibility to make

sure all components are properly assembled and installed using the instructions provided.

INSTALLATION INSTRUCTIONS

1. Remove eight Phillips head screws from top and bottom front of
rack. (See Figure 1)

1

2. Connect the racks by attaching t he ganging hardware (A) at the
top and bottom of the rack using the eigh t Phillips head screws
removed in Step 1. (See Figure 2)

x 8

Figure 1

(A)

2

x 8

(A)

Figure 2

3. Repeat Steps 1 and 2 for the back of the racks.

Milestone AV Technologies, and its affiliated co rpo rat ions a nd s ubs id iaries (collectively, "Milestone"), intend to mak e th is ma nual ac curate and complete. However, Milestone mak es

no claim that the information contained h erein co vers all details, conditions or variations, nor does it provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

©2010 Milest one AV Techn ologies,

a Duchossois Gr oup Company

8821-0 02 01 9 R ev 00

09/10