Page 1
INSTALLATION INSTRUCTIONS
Model FSB-4101
INTERFACE BRACKET
VESA 200mm x 100mm / 100mm x 100mm
BEFORE YOU BEGIN
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, or you have any questions about this installation, contact Chief
Manufacturing Customer Service at 1-800/582-6480
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
PART NO. 8804-000034 (Rev. E)
©2005 Chief Manufacturing
www.chiefmfg.com
Printed in USA 09/05
Page 2
Model FSB-4101
ITEM DESCRIPTION QTY.
10 Interface Bracket 1
20 3/8" Nylon Spacers 6
30 3/4" Nylon Spacers 6
40 1/8" Nylon Spacers 6
50 M4 X 12mm Phillips Pan Head Screws 6
60 M4 X 20mm Phillips Pan Head Screws 6
70 M4 X 30mm Phillips Pan Head Screws 6
80 M4 X 6mm Phillips Pan Head Screws 6
80
30
70 20 60
40 50
10
WARNING: FLAT PANEL DISPLAYS ARE
EXTREMELY FRAGILE. If Display Uses a Screw Size
Other Than M4, DO NOT USE M4 Screws provided.
Monitor Damage Could Occur.
Installation Instructions
2
Figure 1:
Page 3
Installation Instructions
Display
Interface
Bracket
1/8" Nylon Spacers (6)
M4 x 12mm Screws(6)
Display
Interface
Bracket
3/8" or 3/4" Nylon Spacers(6)
M4 x 20mm Screws(6)
M4 x 30mm Screws(6)
Display
Interface
Bracket
Q2 Mount
Latching Flag
Display
Interface
Bracket
Mounting Button
Phillips Head
Screw (4)
VESA Mount
Model FSB-4101
NOTE: If the flat panel display has a table stand
attached, remove existing stand.
Flush Mount Installation
1. Secure the Interface Bracket to the Display using 1/8"
Nylon Spacers and M4 x 12mm screws
(see Figure 2).
NOTE: Length of mounting screws is dependant
upon length of spacer used.
Mount to Q2 System
1. Install flat panel disp lay , with interface plate att ached,
on Q2 mount (see Figure 4).
2. Move latching flag of Q2 mount to secure display.
Figure 4:
Figure 2:
Recessed Mount Installation
1. Place four Nylon spacers (3/8" or 3/4" as necessary)
over four mounting holes in Display (see Figure 3).
2. Secure the Interface Bracket to the Display using M4
x 20mm or M4 x 30mm screws depending upon
spacer used. (see Figure 3).
Conversion to VESA 75mm Mounting/Centris®
Mounts
1. Remove Phillips head screws and mounting buttons
from the interface bracket.
Figure 5:
2. Using M4 x 6mm screws, attach the interface bracket
to any VESA 75mm x 75mm mounting device.
Figure 3:
3
Page 4
Model FSB-4101
Installation Instructions
4
Loading...