CHIEF FCA101 User Manual
INSTALLATION INSTRUCTIONS
FCA101 Fusion™ Security Collar Kit
The FCA101 security collars are designed to fit all Fusion™ series mounts. They provide additional security by preventing the mounted
screen from sliding laterally and being completely removed from the uprights.
Unpack carton and verify kit contents. If any listed parts are missing, immedia tely contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
(2) FCA101 Security Collars (2) 5/16-18 x 3/8" Set Screws
(2) 5/16-18 x 3/8" Security Set Screws (1) 5/32 x 6" Security Allen Wrench
Mounting Scenarios
(3)*
(2)*
(1)*
Figure 1
*can be installed on ei ther
the top or bottom rail
3
security
collars x 2
Note: Scenario 3 shown
set screws x 2
Figure 2
Installation Instructions
1. Position uprights on rails at desired viewing position.
NOTE: Collars should be ins talled as close to the upr igh ts as poss ib le in order to preve nt any slid ing . They can be i ns talled either just i nsi de
each upright (1), just outside each upright (2) or on either side of a single upright (3) in order to be effective. (See Figure 1)
2. Slide FCA101 security collars onto rails at desired locking locations.
NOTE: Collars can be installed on either the top or bottom rail.
NOTE: Additional collars (sold as separate kits) may be used for increased security.
NOTE: If some lateral shift is desired, collars can be installed further from the uprights in order to allow for limited lateral shift capability.
3. Secure collars to rails using either security or non-security set screws. (See Figure 2)
Chief® and Fusion™ are registered trademarks of Milestone AV Technologies. All rights reserved.
Milestone AV Technologies, and its affiliated co rpo rat ions a nd s ubs id iaries (collectively, "Milestone"), intend to mak e th is ma nual ac curate and complete. However, Milestone mak es
no claim that the information contained h erein co vers all details, conditions or variations, nor does it provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
©2010 Milest one AV Techn ologies,
a Duchossois Gr oup Company
8800-0 02 05 2 R ev 00
01/10
Loading...