
INSTALLATION INSTRUCTIONS
CSACLIPS
ConnexSys™ Cable Management Clips
CSACLIPS are designed for compatibility with Chief® ConnexSys™ Series video wall mounting system. See the specific installation
instructions provided with the mount for additional installation information.
P ARTS
A (25)
[7-1/2" cable tie]
B (25)
[Clip]
1. Place cable clip (B) into rail/strut channel. (See Figure 1)
2. Turn cable clip 90° in either direction until cable clip is vertical.
(See Figure 1)
2
1
(B)
Figure 1
3. Route cables and RapidDraw release cords along rails/strut
channels, and through cable clips.
4. Fasten cables and cords to cable clips (B) using cable ties (A),
as necessary.
Milestone AV Technologies, and its affiliated co rpo rat ions a nd s ubs id iaries (collectively, "Milestone"), intend to mak e th is ma nual ac curate and complete. However, Milestone mak es
no claim that the information contained h erein co vers all details, conditions or variations, nor does it provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief, a products division of Milestone AV Technologies
6436 City West Par kway, Eden Prairie, MN 553 44
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
©2015 Milestone AV Technologies
8800-002724 Rev00
04/15